KAYOBA 956125 Gas Kitchen Hob Instruction Manual

KAYOBA 956125 Gas Kitchen Hob

SAFETY INSTRUCTIONS

Read all the instructions and safety instructions carefully before use, and familiarise yourself with the product before connecting it to the gas cylinder. Save these Operating Instructions for future reference.

• Check that the seals between the gas cylinder and the product are tight and in good condition before connecting the gas cylinder. Replace a seal immediately if it is damaged or worn, otherwise the product must not be used.
• Do not use the product if it leaks, is damaged, or not working properly.
• Place the product on a stable, level surface.
• Do not use the product near flammable substances, or near a wall or roof.
• The gas container must be changed in a well-ventilated location, ideally outdoors, and away from open flames and other ignition sources. Keep onlookers and pets at a safe distance. Never modify the product in any way. Repairs must only carried out by an authorized service centre.
• In the event of a gas leak (smell of gas) take the product outside immediately to find the leak. Leak tracing may only be performed using soapy water, never with an open flame.
• The product is only intended for outdoor use.
• The product must only be used with propane, isobutane, or a mixture of butane. Other types of gas cylinders can result in a risk of personal injury and/or material damage.
• Accessible parts can be hot. For safety reasons it is recommended to wear gloves. Keep children away from the product.
• The product is only intended to be used with a screwed-on gas cylinder.
• Place the product on a level, stable surface. Never move or tilt the product when it is lit.
• Never use the product near flammable objects or substances. Keep flammable items, such as clothes, sleeping bags etc., at least 1 metre on all sides from the flames on the burner (including above).

GAS CYLINDER

• Do not expose to direct sunlight. Avoid storing at more than 40°C.
• Keep out of the reach of children and at a safe distance from sources of heat.
• Do not burn the gas cylinder. Do not subject the gas cylinder to knocks.
• Recycle used gas cylinders in accordance with local regulations.

SYMBOLS

TECHNICAL DATA

• Output 2900 W
• Size L 82 x W 34 x H 78 mm
• Gas consumption 210 g/h
• Gas type Butane, butane/propane

USE

CONNECTION
Connecting the gas container

1. Turn the gas control clockwise (viewed from in front) until it stops, and check that the sleeve is completely closed.
2. Hold the gas cylinder and the product upright and screw
3. the product on the gas cylinder. Screw tight, but do not overtighten. FIG. 1

NOTE :
The gas cylinder must have a threaded union.

IMPORTANT!
Always check for a gas leak before use.

LIGHTING

• Turn the gas control slowly anti-clockwise and press the spark plug to ignite the burner. If the burner does not light when the control is fully open, close the control again and repeat the process.

• The product is intended for pans with a bottom diameter of no more than 18 cm. Pull the supports to fold them out. FIG. 2
  IMPORTANT!

• Always check before lighting that there are no flammable substances nearby.

• Check that the flame is steady.

• The flame should be straight and pointing up.

• If the wind blows out the flame in the burner, switch off the gas immediately and move the product to a more sheltered place.

• Never leave the product unattended when it is lit.

DISCONNECTING THE GAS CYLINDER

1. 1. Turn off the gas control.
   2. Hold the gas cylinder and the product upright and unscrew the product from the gas cylinder.

NOTE:
The burner is very hot after use. Wait until all the parts have cooled before disconnecting the gas cylinder.

MAINTENANCE

STORAGE
Disconnect the gas cylinder from the product after use and store separately in a dry place out of the reach of children and at a safe distance from sources of heat.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>