HOPE INDUSTRIAL SYSTEMS CP-GL-SS-N2 Cover Plate with NEMA 2 Compression Gland Cable Exit Installation Guide
- October 30, 2023
- HOPE INDUSTRIAL SYSTEMS
Table of Contents
HOPE INDUSTRIAL SYSTEMS CP-GL-SS-N2 Cover Plate with NEMA 2 Compression
Gland Cable Exit
Product Information
The CP-GL-BLK-N2 or CP-GL-SS-N2 Cover Plate is designed with a NEMA 2 Compression Gland Cable Exit. It comes with an access panel and 10-32 screws (8 places) for installation. The product is available in two variants: CP-GL- BLK-N2 with a black finish and CP-GL-SS-N2 with a stainless steel finish.
Product Usage Instructions
- Locate the access panel on the cover plate and route the cables through it to the left.
- Take the provided 10-32 screws and sealing washers and insert them in the screw holes on the cover plate. Two extra screws and washers are inside the cavity.
- Fully tighten all eight screws using a screwdriver.
- Back off one full turn on each screw to allow for proper sealing and to avoid over-tightening.
After following these instructions, the CP-GL-BLK-N2 or CP-GL-SS-N2 Cover Plate with NEMA 2 Compression Gland Cable Exit will be installed securely and ready to use.
OVERVIEW
- Route cables through access panel to the left.
- Use the provided 10-32 screws and sealing washers. Two extra screws and washers are inside the cavity. Fully tighten all eight screws, then back off one full turn.
- 99033B
- December 20, 2022
- www.HopeIndustrial.com.
- International: +1 (678) 762-9790
- UK: +44 (0) 20 7193 2618
- © 2023 Hope Industrial Systems, Inc.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>