Lyfco S01BB Heated Towel Rails User Manual
- October 30, 2023
- Lyfco
Table of Contents
Lyfco S01BB Heated Towel Rails
Product Information
The Single Bar Heated Towel Rails come in four models: S01B, S01BB, R01B, and R01BB. They are designed to heat towels and keep them warm and dry. The towel rails have a single bar and are made of durable materials that can withstand moisture and heat. The rails must be installed by a professional to ensure safety and proper functioning.
Product Usage Instructions
- Open the package and ensure that all necessary mounting accessories are included.
- Using the hex key, remove the fixing base from the towel rail.
- Check your concealed power wires before installing the fixing base to the wall.
- Mark the center distance for your model and ensure that the line between these two points is level.
- Drill a hole approximately 30mm deep where the towel rail bracket will be positioned.
- Install the two fixing bases to the wall, ensuring that the hot wire, ground wire, and zero wire are correctly connected to avoid short circuit.
- Remount the towel rail onto the two fixing bases.
- Secure the bracket with the screw provided.
Note : Please read the safety information on the previous page carefully before mounting the towel rail. Also, it is recommended to dispose of this product responsibly to promote sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased.
Single Bar Heated Towel Rails
（Single bar）: S01B,S01BB,R01B,R01BB
INSTALLATION
Mounting towel rail:
- Please note: We advise that the towel rail should should be installed by a professional.
- Please read the safety information on the previous page carefully before mounting.
For example:
- First, open the package, check the towel rail and the mounting accessories.
- Take off the fixing base from the towel rail by the Hex key.
- Confirm your concealed power wires before you install the fixing base to the wall.
- Mark the centre distance for your model. And it is important that the line between these two points is level Drill a hole approximately 30mm deep where the towel rail bracket to be pasitioned.
- Install these two fixing bases to the wall.
- Connect the rail’s cable to the power wires to avoid short circuit.
- Remount the towel rail on the two fixing base.
Secure the bracket with the screw provided.
CAUTION： Risk of electric shock
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
Konsumentkontakt Arc E-commerce AB
Box 3124
13603 Haninge
Sverige