Robert Stevenson Lighting EC1319C Exposed Bulb Metal Vanity Light Instruction Manual
- October 30, 2023
- Robert Stevenson Lighting
Table of Contents
Robert Stevenson Lighting EC1319C Exposed Bulb Metal Vanity Light
Product Information
The EC1319C/EC1320C/EC1321C is a lighting fixture that comes with a wire connector, mounting bracket, fixture body, and three bulbs (not included). It also includes fixture mounting screws, long screws, and barrel knobs. The wattage caution label near the socket should be referred to for the maximum rated wattage to avoid exceeding the maximum wattage listed.
Product Usage Instructions
Before installation, make sure to turn off the main power to avoid the risk of electrical shock. The following steps illustrate the assembly and installation process:
- Attach the wire connector to the outlet box.
- Mount the bracket using the two fixture mounting screws (a).
- Attach the fixture body (C) to the mounting bracket using two long screws (b).
- Insert three bulbs (D) into the sockets. Ensure that the maximum rated wattage is not exceeded.
- Attach the barrel knobs (c) to the fixture body.
- Turn on the main power and test the light fixture to ensure it is functioning properly.
Note : The diagram provided in the manual is a representative drawing and may not exactly match the style of your light fixture.
Components List
| Item | Description | Quantity | Item | Description | Quantity |
|---|---|---|---|---|---|
| A | Wire Connector | 3 | D | Bulb (Not Included) | 3 |
| B | Mounting Bracket | 1 | |||
| C | Fixture Body | 1 |
Hardware List
| Item | Description | Quantity | Item | Description | Quantity |
|---|---|---|---|---|---|
| a | Fixture Mounting Screws | 2 | c | Barrel Knobs | 2 |
| b | Long Screws | 2 |
WARNING
TO AVOID THE RISK OF ELECTRICAL SHOCK, BE SURE TO TURN OFF THE MAIN POWER
PRIOR TO INSTALLATION.
CAUTION
Refer to the wattage caution label located near the socket for maximum rated
wattage. Do not exceed the maximum wattage listed.
ASSEMBLY & INSTALLATION
-
Carefully unpack the fixture and take the parts out of the mounting package. Lay all the fixture components in a clean and flat surface.
-
With Fixture Mounting Screws (a) facing outward on the Mounting Bracket (B), attach the Bracket to the existing outlet box with long screws (b) (not included).
Note : The side of the mounting plate marked “GND” must face out. -
Connect the GROUND WIRE from the fixture and canopy to the junction box, and secure the electrical connections using the Wire Connector (A). Connect the NEUTRAL (OR WHITE) WIRE from the fixture to the NEUTRAL WIRE from the power supply with the Wire Connector (A). Connect the HOT (OR BLACK) WIRE from the fixture to the HOT WIRE from the power supply with the Wire Connector (A). Tuck wires neatly back into the outlet box.
-
Lift Fixture Body onto the Mounting Bracket (B) then adjust and lock in place with Barrel Knobs (c).
-
Screw Bulb (D) (not included) into the socket and make sure not to exceed the maximum wattage specified on the fixture’s wattage label. MAXIMUM 60 Watts
Note: (1). The above diagram illustrates the installation of your light fixture. This is a representative drawing and may not exactly match the style of your light fixture