TOTALCOOL TF35 Portable Fridge Freezer User Guide

TOTALCOOL TF35 Portable Fridge Freezer

Product Information

The TF35 is a portable fridge/freezer made of PP/ABS material. It has a total capacity of 35 liters and weighs 14.0kg. The external size of the fridge is 690mm x 345mm x 382mm, while theinternal size is 492mm x 261mm x 288mm. The fridge operates on an input power of 12v/24v/220v and has a DC fuse of 15 Amp. The power consumption of the fridge is 45 Watt.

The TF35 is manufactured by Totalcool Ltd, a company registered in the United Kingdom with company number 9633704. For more information about the product and the company, visit their website at www.totalcool.co.uk.

Product Usage Instructions

1. Before using the TF35, ensure that it is placed on a level surface and the air vents are not blocked.
2. Connect the fridge to a power source using the appropriate adapter (12v/24v/220v).
3. Turn on the fridge by pressing the power button.
4. The temperature can be adjusted using the temperature control buttons. Press the “-” button to decrease the temperature and the “+” button to increase it.
5. To switch between fridge and freezer modes, press and hold the mode button for 3 seconds.
6. When not in use, turn off the fridge and unplug it from the power source. Clean the interior and exterior of the fridge with a damp cloth and mild detergent.

NOTE: Do not use abrasive cleaners or solvents on the fridge as this may damage the material. Also, do not place hot food or drinks directly into the fridge as this may cause damage to the interior. Allow them to cool down first before placing them into the fridge.

Safety Instructions

WARNING! Failure to obey these warnings could result in malfunction of your device and possible injury for yourself and other users.

• Do not operate the device if it is visibly damaged.
• Do not block the gaps of the device with things like pin, wire, etc.
• Do not expose the device to rain or soak it in water.
• Do not place the device near naked flames or other heat sources (heaters, direct sunlight, gas ovens etc.)
• Do not store explosive substances like spray cans with flammable propellants in the device.
• Before starting the device, ensure that the power supply line and the plug are dry.
• Check if the voltage specification on the type plate matches that of the energy supply.
• Once unpacked and before turning on, the device must be placed on a level surface for more than 6 hours.
• Make sure that the device stays horizontally when it is running. The tilt angle must be less than 5° for long time running and be less than 45° for short time running.
• The refrigerator must be well ventilated for heat dissipation and make sure to keep some space around it. (Back Space?200mm, Side Space?lO0mm)
• The device may only be repaired by qualified personnel. Improper repairs can lead to safety hazards. If the power cable is damaged, it must be replaced by the manufacturer, customer service or a similarly qualified person in order to prevent safety hazards.

NOTICE!

• The device can be used by children aged 8 or over, as well as by persons with reduced physical, sensory or mental capabilities or a lack of experience and/or knowledge, providing they are supervised or have been taught how to use the device safely and are aware of the resulting risks.
• Children must be supervised to ensure that they do not play with the device.
• The installation of DC power in the vehicle must be handled by qualified electricians.
• Never pull the plug out of the socket by the cable.
• Disconnect the device or switch it off when you turn off the engine. Otherwise you may discharge the battery.

CAUTION!

• Food is suggested to be stored in its original packaging or in suitable containers.
• Set suitable temperature for food or medicine stored in the device. Refer to recommended temperature for common food on Page3.

Product Features

• High-efficiency DC compressor and conversion module.
• CFC free and great heat insulation.
• DC12/24V or AC 100~240V (using the adapter) power supply.
• Fast cooling to -20°C/-4° F(based on 25°C/77° F room temperature).
• Intelligent battery protection system.
• Digital display control panel for temperature setting.
• Built-in LED light, cup holder design and wire storage basket.

Product Structure

Function and Operation

• Power Supply: connect to DC 12V/24V or AC 100~240V (using the adapter) power supply.
• Display Screen Initialization: the screen will be on for 2 seconds after connecting to the power supply.
• Power On/Off: press to switch ON/OFF.
• Temperature Setting: press the button or for temperature setting, press the button to increase or the button  to decrease the temperature. The setting will be saved automatically after stopping operating for 4 seconds {Note: the temperature displayed is the current temperature of the compartment, it will take a while to reach the set temperature.) Temperature setting range: -20~20°C (-4~68°F)
• Cooling Mode: under the running state, press to switch between MAX{fast cooling) and ECO(Energy saving Mode).{*Factory setting is MAX.)
• Teperature Unit Setting: switch off the fridge, long press for three seconds until El displays, keep pressing until ES displays. then press or to select Celsius or Fahrenheit.{*Factory setting is 0C.)
• Battery Protection Mode: under the running state, long press for three seconds until screen flashes, then press again to select protection mode H(High), M(Middle) and L(Low){*Factory setting is H.)

Due to the different output voltages between vehicles, H should be set when the product is connected to car power, and M or L should be set when it is connected to a portable battery or other back-up battery.
The battery gear should be set from H to M or from M to L if there is a voltage protection code Fl shown on the panel. The battery gear should be set to H if the product keeps working after turning off the car engine, or the product may drain the battery.

Voltage Reference

the voltage is theoretical value, there may be a deviation in different scenarios.

• Reset: switch off the fridge, long press O for three seconds until El displays, under El mode, long press • • at the same time until the screen displays “888”.

Recommended temperature for common food:

5.Cleaning and Storage

• Cleaning:

  • Unplug the device first to avoid electric shock.
  • Use a wet cloth to clean the device and dry it.
  • Do not soak the device in water and do not wash it directly.
  • Do not use abrasive cleaning agents as these can damage the device.

• Storage:
  If the device will not be in use for a long time, please follow the steps:

  • Turn off the power and remove the plug.
  • Remove all the items stored in the device.
  • Wipe off excess water from the fridge with a soft rag.
  • Put the device in a cool and dry place.
  • Leave the lid slightly open to prevent odors from forming.

• Defrosting:
  Humidity can form frost in the interior of the cooling device or on the evaporator. This reduces the cooling capacity. Defrost the device in good time to avoid this.

  • Switch off the device.
  • Take out the contents from the device.
  • Keep the lid open.
  • Wipe off the defrosted water.

Never use hard or sharp tools to remove ice or to loosen objects which have AA frozen in place.

Warranty and Maintenance

If the device becomes malfunctional, limited warranty will be provided for 2 years from the date of purchase, except following situations:

• Contrived damage.
• Damage caused by force majeure such as earthquake, conflagration, etc.
• Damage from inappropriate use or violating this instruction.
• Damage or malfunction caused by disassembling without permission.

Troubleshooting

Refrigerator does not work

| Check if the switch is on.
Check if the plug and socket are connected well.
Check if the fuse has been burnt.
Check if the power supply has malfunctioned.
Switching on/off the fridge frequently may cause start delay of the compressor.

Refrigerator compartments are too warm

| The door is opened frequently.
A large amount of warm or hot food was stored recently. Wait for the refrigerator to reach its selected temperature.
The refrigerator has been disconnected for a period of time.
Food is frozen| The temperature was set too low, please increase the temperature.
There is a “water flow”

noise from inside the fridge

| It’s a normal phenomenon, caused by the flow of refrigerant.
There are waterdrops

around the refrigerator casing or door gap

|

It’s a normal phenomenon, the moisture will condense to water when it touches a cold surface of the refrigerator.

The compressor is slightly noisy when starting| It’s a normal phenomenon, the noise will be reduced after the compressor works stably.
Code Fl displayed| Possible cause: low voltage to fridge.

Adjust the battery protection from H to M or from M to L.

Code F2 displayed| Possible cause: condenser fan is overloaded. Disconnect power to fridge for 30 minutes & re-start.
Code F3 displayed| Possible cause: the compressor starts too frequently. Disconnect power to fridge for 30 minutes & re-start.
Code F4 displayed| Possible cause: compressor not kicking in. Disconnect power to fridge for 30 minutes & re-start.
Code FS displayed| Possible cause: overheating of the compressor & electronics. Disconnect power to fridge for 30 minutes & re-start.
Code F6 displayed| Possible cause: no parameter can be detected by the controller. Disconnect power to fridge for 30 minutes & re-start.
Code F7 or FB displayed| Possible cause: temperature sensor is faulty. Contact seller for service.

Technical Information

Due to product improvement, the technical information might be different from actual information, please refer to the rating label on the product.

Disposal:

Place the packaging material in the appropriate recycling waste bins wherever possible. If you wish to finally dispose of the product, ask your local recycling center or specialist dealer for details about how to do this in accordance with the applicable disposal regulations.

Totalcool Ltd
Company number: 9633704 United Kingdom
www.totalcool.co.uk

References

• Home - Totalcool

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>