Levven GPC20 20 AMP OnOff Relay Wireless Controller Installation Guide
- June 4, 2024
- Levven
Table of Contents
GPC20 20 AMP OnOff Relay Wireless Controller
Installation Guide
Installation Guide
- TO AVOID FIRE, SHOCK, OR DEATH: TURN OFF POWER at a circuit breaker or fuse and verify that power is off before installing a Levven product.
- Install and/or use Levven products in accordance with local electrical codes and regulations.
- Leven power controllers are to be mounted to listed electrical junction boxes of the suitable size to satisfy the electrical code in your area. We recommend using plastic junction boxes for best performance or if that is not possible, ensuring the power controller antenna is sticking out of a metal junction box. This recommendation does not apply to switches.
- If you are unsure about any of these instructions, consult a qualified electrician.
Wiring
|
---|---
Power controllers are to be mounted in junction boxes of suitable size to
satisfy the local electrical code.| Connect the white wires from the power,
load, and power controller together.
|
Connect the black power wire to the black wire of the power controller and to
one of the controller’s blue dry contact wires.| Connect the black load wire
to the other blue dry contact wire of the power controller.
Grouping
Grouping controllers together permits one switch to operate multiple controllers or add Levven Q to access controllers from a mobile device. Only controllers with no previously saved group or pairing can join a group. NOTE: If there is no grouping request received within 60 seconds, the controller will quit the grouping procedure.
|
---|---
Press and release the pair button on the first controller to initiate
grouping. This controller’s LED will blink green.| Press and release the pair
button on the new controller being added to the group. This controller’s LED
will blink green.
|
Both LED’s on each controller will start blinking red and green to confirm a
signal is received.| Press and release the pair button on the first controller
again to complete a grouping. Both LEDs will flash green 3 times to confirm
the grouping.
Pairing
Pairing a switch to a controller establishes a connection to send on, off and dim commands. NOTE: If there is no pairing request received within 60 seconds, the controller will quit the pairing procedure.
|
---|---
Press and release the pair button on the controller to initiate pairing. This
controller’s LED will blink green.| Squeeze and release both ends of the
switch simultaneously.
|
The LED on the controller will start blinking red and green to confirm a
signal is received.| Press and release the pair button on the controller to
complete pairing.
Its LED will flash green 3 times to confirm pairing.
If pairing is unsuccessful, the LED will flash red 3 times
Please restart from Step 7
For customer support or inquiries visit levven.com/help or call 1
(844)-553-8836
Specifications
| Input | Paired Switches | Wireless range |
|---|---|---|
| 85-277VAC, 0.1-20A, 50/60Hz | Up to 1 0 Switches | Up to 75 m / 250 ft |
| Radio frequency | Encryption | Color |
| 900 MHz band | 128-bit | Blue |
| Operating temperature | Enclosure rating | Longevity |
| -40C to 50C | Indoor use only | 65+ years at 15 operations per day |
Levven Controls GPC20 controller / controleur /controlador
Certified to/ Certifi~ ~ / Certificado para CSA Std. C22.2 #14
Conforms to/ Conforme ~/ De acuerdo a UL 244A & 508
FCC ID: 2ADH9 G2CF, IC ID: 12453A-G2CF
C/USETLListed4010961
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>