DELTACO GAMING GAM_135_W LINE Premium Gaming Dual Monitor Arm User Manual
- October 30, 2023
- DELTACO GAMING
Table of Contents
DELTACO GAMING GAM_135_W LINE Premium Gaming Dual Monitor Arm
Product Information
The Maximum RF output (EIRP) is the maximum allowed level of radio frequency (RF) power that a device can emit from its antenna. It is measured in units of decibels relative to one watt (dBW) and takes into account the transmitter power, antenna gain, and cable loss.
Product Usage Instructions
When using the product, it is important to ensure that the Maximum RF output (EIRP) does not exceed the limit set by regulatory authorities in your country. Exceeding this limit can cause interference with other devices and may result in penalties or fines. To determine the Maximum RF output (EIRP) of the product, refer to the product specifications or consult with the manufacturer. When setting up the product, ensure that the antenna gain and cable loss are within the recommended range specified by the manufacturer. If you are unsure about the Maximum RF output (EIRP) or how to set up the product properly, seek advice from a qualified product expert before use.
INSTALLATION
- Read the entire instruction manual before you sta t installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact your retailer for assistance.
- Caution: Usage together with products heavier than the rated weight may result in instability which can cause possible injury.
- The product must be attached as specified in assembly instructions. Improper installation may result in serious injury.
- Safety gear and proper tools must be used. This product should only be installed by a qualified person.
- Make sure that the supporting surface will safe ly support the combined weight of the equ ipment and all attached hardware and components.
- Use the mounting screws provided and do not over tighten the mounting screws.
- This product contains small items that cou ld be a choki ng hazard if swallowed. Keep these items away from children.
- This product is intended for indoor use on l y. Using this product outdoors could lead to product failure and personal injury.
- Important: Ensure that you have received all parts according to the component checklist prior to instar llation. If any parts are missing or faulty, contact Deltaco o the retai ler where you purchased the product.
- Caution: Do not exceed the marked max weight Serious injury or property damage may occur!
- Check that the product is secure and safe to use, at regular intervals (at least every three months).
Warning: Stored energy
Hold the monitor arm firmly with 1 hand on each opposite side. Ask another
person to cut off the cable tie. Slowly release the pressure until it is fully
extended.
Caution: Do not put your hands or fingers near or around the joint
.
Adjustments Hold the monitor arm horizontally to avoid damage to monitors or monitor arm. Ask for help from a 2nd person if needed.
If the monitor arm is falling, turn it counterclockwise until it stays in place.
If the monitor arm is rising too much, turn it clockwise until it stays in
place. 
Storage for hex keys.
Caution: Do not push the monitor arms outside the arrows’ areas. To avoid
tipping over.
If the monitor does not stop at desired position, tighten the screws
.
If the monitor does not stop at desired position, tighten the screws.
Control the LEDs with the remote control. Place the remote control on the magnet when it is not being used. To connect to a USB power source you must first connect the USB cable as in step (1 ), figure 1 0C
Adjustments
- On/off
- Increase or decrease LED speed.
- Next or previous mode.
- Press 1 time: automatic mode. Press 7 times: mode with 7 static colours.
- Increase or decrease brightness.
- Pair button: press and hold for 5 seconds to pair or unpair the remote control to the product. The product will flash green 3 times to confirm the pairing. When you unpair it will flash white 3 times. Note: The product is already paired, so pairing is not needed. However, it could be used for troubleshooting.
- Set button: While the product is in automatic mode (4.), it changes between different LED loops. Press the set button (7.) and then the pair button (6.) to keep repeating the current LED loop.
- Static colours.
SIMPLIFIED EU DECLARATION OF CONFORMITY
The simplified EU declaration of conformity referred to in Article 10(9) shall
be provided as follows: Hereby, DistIT Services AB declares that the radio
equipment type wireless device is in compliance with Directive 2014/53/EU. The
full text of the
EU declaration of conformity is available at the following internet
address:
www.aurdel.com/compliance/
Disposal of electric and electronic devices EC Directive 2012/19/EU This product is not to be treated as regular household waste but must be returned to a collection point for recycling electric and electronic devices. Further information is available from your municipality, your municipality’s waste disposal services, or the retailer where you purchased your product.
www.deltacogaming.com
Made in China
DistIT Services AB,
Suite 89,
95 Mortimer Street,
London,
W1W 7GB,
England DistIT
Services AB,
Glasfibergatan 8,
help@deltaco.eu
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>