MEISDA SC98F Toolbox Fridge Instruction Manual

MEISDA SC98F Toolbox Fridge 5

Product Information

• The appliance is a fridge
• The supply cord must be replaced by the manufacturer, its service agent, or similarly qualified persons if damaged
• Do not store explosive substances such as aerosol cans with a flammable propellant in the fridge The LED lamp must be replaced by the manufacturer, its service agent, or similarly qualified persons if damaged
• The fridge is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
• Children being supervised should not play with the appliance
• The foaming agent used in the fridge is flammable
• Scrapping and recycling of the fridge should be handled by specialized companies to prevent hazards to the environment or other dangers from being caused
• The rated current is 1.0A Cyclopentane
• Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance

Product Usage Instructions

1. Do not store explosive substances such as aerosol cans with a flammable propellant in the fridge.
2. Ensure that the supply cord is not trapped or damaged when positioning the appliance.
3. The LED lamp must be replaced by the manufacturer, its service agent, or similarly qualified persons if damaged.
4. Do not allow children to play with the appliance.
5. The fridge is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction.
6. When scrapping or recycling the fridge, it should be handled by specialized companies to prevent hazards to the environment or other dangers from being caused.
7. Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance.

Installation Instruction

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard
• This appliance is intended to be used in household and similar applications such as
  • staff kitchen areas in shops, offices and other working environments;
  • farm houses and by clients in hotels, motels and other residential type environments;
  • bed and breakfast type environments;
  • catering and similar non-retail applications.
• Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction”
• Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer”
• Do not damage the refrigerant circuit”
• Do not use electrical appliances inside the food storage compartments of the appliance, unless they are of the type recommended by the manufacturer”
• Do not store explosive substances such as aerosol cans with a flammable propellant in this appliance.
• If the LED lamp is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard”

The instructions state that:

• the appliance is not to be used by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
• children being supervised not to play with the appliance

Diagram

Specification

The Above Specification Are Sunject To Improvements

Safety Cautions

•  This unit uses AC220-240V/50Hz power and there should be a 500va stabilizer if the voltage fluctuation exceeds AC198-264V.

•  The user should hold the plug when the power is on/off, dragging or pulling the power cord is prohibited.

•  Do not remove the power cord or plug

•  Must use dependent socket and reliable ground wire. Ground wire must not connect with the null line of the gas pipe, warm gas pipe, water pipe and must be single power

•  Never splash water on the unit directly.

•  Keep away from explosive, hazardous goods such as ether, gas, alcohol, bonding agents, gunpowder etc.

•  Keep away from spray of inflammables such as paints, coating materials etc.

•  After the unit is switched off, it should not be restarted within 5 minutes.

•  Do not leave the power cord under any heavy objects including the unit itself.
  Do not drill holes or install other objects on the casing.

•  This cooler is not suitable for storage pharmaceutical products

Portage and storage

•  Keep the unit vertical when carrying the unit, the angle to the horizontal line should not be over 50 °, otherwise it will damage the compressor and affect normal operation of the unit.
•  The unit should be place on a solid and firm ground, take away the bottom pack to lower the shock and noise.
•  Leave at least 20 cm of distance between the back of the unit and the wall for ventilation and leave a space with an open angle of 160 ° for the door.
•  Keep the unit away from heat sources and avoiding direct sunlight.
•  Never place the unit on a location where water can reach or with high moisture. Splashed water and dirt should be wiped off in time by using a soft cloth.
•  Do not place the unit in the environment cold enough to be iced.

Preparation

• Remove the carton and packing foam (including the bottom foam) before using.
• Clean the unit before using.
• Adjust the foot to make the unit steady according to the ground condition to lower the shock and noise.
• After moving the unit, place the unit for 30 minutes before switching it on.
• Running: close the door and connect the power, turn on the lamp switch on the control panel, the lamp is on. Half an hour later, the temperature inside the case lower apparently, it indicates the unit on be normally used
• After connecting the power, the unit should be kept empty for one hour.

Setting and adjustment of temperature

• Adjust the storage temperature through the temperature controller located in the internal of the case(see the picture), adjust the temperature according to the ambient temperature and the foodstuff.
• See the following picture about the knob scale. The temperature adjustable capacity is from “1”-“5”, adjust the storage temperature by turning the temperature controller clockwise. The higher of the number shows the lower of the storage temperature. The knob can turn freely but can’t turn clockwise from “5”to “l “. Factory setting position is on “3”.
• Check if the scale is on an appropriate position before using, frequent adjustment is not appropriate when using. Normally in summer, the ambient temperature is high, anti clockwise turn the knob to “2”, while in winter, the ambient temperature is low, clockwise turn the knob to “4”.
• Position “O” represent stop running.

Storage of articles

• Do not put large amount of articles into the unit at one time, you should leave some space around the foodstuff to let cold air inside the cabinet counter to flow. Keep bottled articles away from the walls of interior cabinet so as not to freeze it until broken.
• Do not put warm food into the unit directly until they are cooled under normal temperature, it will facilitate to lower its energy consumption and prolong service life of the compressor.

Disconnect the power supply before maintenance for the machine!

• Keep the door gasket clean, remove it from the door and wash it. Dry and seal it as before Putting some talcum powder on the magnetic surface would prolong its service life.
• Bule replacement: remove the lamp shade, take out the bulb, replace with a new bulb, then mount it again ..
• If there is heavy frost on the evaporator after long usage, take out the stuff inside the case, disconnect the power, the frost will melt automatically, clean up the water and connec1 the power again.
• Use a soft cloth and dip some water or soap (Non-caustic, neutral detergent is also available) to clean the unit. Dry the unit after cleaning to avoid rust.
• Do not use organic liquid, boiled water, washing powder or acid stuff to clean the unit.
• Rinsing the case by water is not allowed, don’t use hard brush, steel brush to clean the case.
• If the unit will not be used for a long time, disconnect the power, clean it by following the above steps, wipe off the water inside the case with a soft cloth.

Caution

• The unit is not suitable for storage of blood, pharmaceutical products and biological products
• Do not place heavy articles on the top of the unit.
• In case of trouble, please ask professional person for service, do not dismantle the unit without prior authority to avoid hazard.

Normal Phenomena

• Sometime hear light sound of water flowing in the unit, this is the sound of refrigeran1 flowing inside the pipe.
• the top ,and the two sides of the casing will be warm, even too hot.
• In a humidity place, there is dew on the casing or the door, it can dry by dry cloth.

Troubleshooting guide

Matters needing attention
The foaming agent used in FRIDGE is flammable. Scrapping and recycling o f t h e FRIDGE shall be handled by specialized companies to prevent hazards to the environment or other dangers from being caused.

WARNING

• When positioning the appliance, ensure the supply cord is not trapped or damaged.
• Do not locate multiple portable socket-outlets or portable power supplies at the rear of the appliance

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>