Zip HydroTap G5 Chilled and Sparkling Water Tap Instruction Manual
- June 10, 2024
- Zip
Table of Contents
Zip HydroTap G5 Chilled and Sparkling Water Tap
Product Information
The HydroTap G5 BCS Home is a water dispensing system that provides filtered boiling, chilled, and sparkling water. It comes with the HydroTap Arc Plus tap and a Command Centre for easy control. The product requires proper ventilation and a clearance envelope for installation. It also has an air inlet cut-out and air outlet louver for proper air circulation. The product comes with a mains cold water isolation valve, IEC Flex & Plug, and a CO2 gas cylinder. The HydroTap G5 BCS Home is compatible with standalone Font with Arc Plus Tap.
Product Usage Instructions
- Contact your local service provider if ventilation is not suitable for installation.
- Position the Tap and the Command Centre as close together as possible within the clearance envelope.
- Mount the Tap to dispense into the sink, allowing clearance for a cup or teapot. Alternatively, install it on a Font.
- Create a cut-out in the cabinet floor for the air inlet and towards the top of the cabinet for an air outlet louver (if required).
- Install the mains cold water isolation valve, IEC Flex & Plug, and CO2 gas cylinder.
- Connect the product to a 230-240V, 50Hz power outlet.
- Refer to the cutting detail for the installation of HydroTap Arc/Cube.
- Note that hoses are not shown to scale and cannot be lengthened.
Ventilation requirements
Contact your local service provider if ventilation is not suitable
Clearance envelope
Position the Tap and the Command Centre as close together as possible.
- Air outlet louver (if required) Cut-out indoor/wall, towards the top of the cabinet
- Air inlet cut-out (required) Cut-out in cabinet floor
HydroTap Tap options
HydroTap Arc Plus Tap
HydroTap Cube Plus Tap
Standalone Font
with Arc Plus Tap
Cutting detail
Tap Positioning
Position the Tap to dispense into the sink, allowing clearance for a cup or
teapot. Alternatively, mount on a Font (available as an accessory). Ø35mm hole
for HydroTap Plus Tap
SCALE 1:5 ALL DIMENSIONS IN MM UNLESS OTHERWISE SPECIFIED. INSTALLATION DIAGRAMS ARE FOR ILLUSTRATIVE PURPOSES ONLY. HOSES ARE NOT SHOWN TO SCALE AND CANNOT BE LENGTHENED.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>