Zip 91240 0.5 Micron Water Filter Instruction Manual
- June 2, 2024
- Zip
Table of Contents
Zip 91240 0.5 Micron Water Filter
WARNINGS AND PRECAUTIONS
WARNING: For the continued safety of this product, it must be installed, operated, and maintained in accordance with the manufacturer’s instructions. Read this data sheet to compare the capabilities to your actual water treatment needs before purchasing.
When the filter is fitted to an appliance, please refer to the appliance
owner’s guide for more product-specific information and advice on how to avoid
contamination from improper handling and installation.
Branded Water Filter cartridges are not covered by standard supplier warranty
as filter life may vary according to water quality and rate of use.
To reduce the risk associated with property damage due to water leakage:
- Do not expose filters to the elements of nature. This product is designed for indoor use only.
- Do not install where exposed to direct sunlight or temperatures below 35°F / 2°C or greater than 100°F / 38°C. To protect from freezing, remove filter cartridge when temperatures are expected to drop below 39°F / 4°C.
Instructions: Filter cartridge replacement
- Turn OFF the water supply.
- Relieve the system pressure by dispensing some water.
- Place an absorbent cloth or towel under the cartridge to catch water that may spill.
- Grasp the filter cartridge and rotate it a quarter-turn to the left. Gently pull down.
- Unpack the replacement cartridge. Avoid touching the filter O-rings and filter opening as this may cause bacterial contamination of the cartridge. Remove its sanitary cap and write today’s date where shown on the label.
- Moisten the O-rings with water.
- Align the key tabs and insert the new cartridge upwards into the filter head.
- Turn the cartridge to the right until the cartridge locks into place.
- Turn the water ON and check for leaks.
- Wipe up any spills and dispose of the spent filter cartridge and packaging thoughtfully.
91240 Performance Data Sheet: Reduction Info
Zip 91240 cartridge tested in 0.5 Micron system according to NSF/ANSI 42 & 53 for the reduction of substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 & 53. The Zip 91240 cartridge has been tested and certified under AS/NZS 3497 and the performance of this product has been verified and substantiated as the test data summarised below indicates. These substances may not be in your water.
Substance| aNHMRC ADWG or bUSEPA
SDWA MCL
| Average influent concentration| NSF/ANSI influent challenge concentration|
% reduction reqt / Max. permissible product water concentration| Maximum
effluent concentration| Minimum % reduction| Average % removal| Average
effluent concentration
---|---|---|---|---|---|---|---|---
NSF/ANSI 42 – Aesthetic Effects
Chlorine| 0.6 mg/L| 1.98 mg/L| 2.0 mg/L ± 10%| ≥ 50%| 0.09 mg/L| 95%| 97.15%|
0.06 mg/L
Nominal Particulate Reduction, Class I (≥ 0.5 µm to < 1 µm)| –| 383 333
particles/ mL
| At least 10000 particles/mL| ≥ 85%| 2500
particles/ mL
| 99.31%| 99.56%| 1683
particles/ mL
NSF/ANSI 53 – Health Effects
Cysts (3-4 micron particles)| 99.5%
reduction
| 307 500
Oocysts/L
| Minimum 50000 Oocysts/L| 99.95%| 67 Oocysts/L| 99.98%| 99.99%| 37.3
Oocysts/L
Asbestos| 7MFL| 13.3 MFL| 107 to 108 fibres/L; fibres greater than 10 µm in length| 99%| 4760
fibres/L
| 99.96%| 99.98%| 2890
fibres/L
- MCL— Maximum Contaminant Level
- MFL— million fibres per litre
- Cysts— Cryptosporidium, Giardia Lamblia, Entamoeba Histolytica
- mg/L— milligrams per litre (1 mg/L = 1 part per million)
a National Health and Medical Research Council Australian Drinking Water
Guidelines
b United States Environmental Protection Agency (USEPA) Safe Drinking Water
ACT.
Testing performed under standard laboratory conditions, actual performance may
vary.
Replacement Cartridge Model Number: Zip 91240
Lab testing conditions:
- pH 7.5 ± 0.5
- temperature 20 ± 2.5 °C (68 ± 5 °F )
- pressure 60 ± 3 psi (4.1 ± 0.2 bar)
- flow rate 0.5 gpm (1.9 lpm) [chlorine reduction]; 0.5 gpm (1.9 lpm) [mechanical reduction]
Use guidelines:
- Nominal flow rate: 0.5 gpm
- Rated capacity: 1500 gallons
- Min/Max working pressure: 10 psi / 125 psi (0.7 bar / 8.6 bar; 70 kPa / 860 kPa)
- Min/Max operating temperature: 35°F / 100°F (2°C / 38°C)
This cartridge meets the domestic water treatment appliance Standard AS/NZS 3497 and NSF/ANSI Standards 42 & 53 for the following water treatment processes:
Class | Treatment type | Function | Pass |
---|---|---|---|
I | Microbiological Status: Bacteriostatic | Will stop bacteria increasing, but | |
will not remove them unless II(a) is passed | N/A | ||
II II(a) | Microbiological Treatment: Bacteria Removal | Will remove or | |
inactivate bacteria | N/A | ||
II(b) | Virus removal | Will remove or inactivate viruses | N/A |
II(c) | Protozoa removal | Will remove or inactivate Cryptosporidium and |
Giardia. Will not remove or inactivate bacteria and viruses unless Class II(a)
and II(b) are passed| PASS
III| Turbidity and particulate removal| Reduces cloudiness| PASS
IV| Taste and Odour reduction| Reduces tastes and odours| PASS
V| Chemical treatment| Decreases certain chemicals| N/A
Zip Water Filter cartridges are not covered by standard Zip warranty as filter life may vary according to water quality and rate of use. Performance will vary based on local water conditions. The substances reduced by this product are not necessarily in your water. This product requires regular replacement to maintain proper operation. Varying chlorine, sediment, or organic substance levels may affect replacement frequency. This product has to be installed according to local plumbing code on the cold-water line. Do not allow exposure to temperatures below 35°F / 2°C. Be sure to change the filter cartridge at least every 1500 gallons or annually, whichever occurs first; or when you detect a change in taste or odour, or a decrease in flow. 1500 gal is approximately equal to using 4 gal daily for one year.Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.
Distributed by
Zip Heaters (Australia) Pty Ltd: 67 Allingham Street, Condell Park NSW
2200
Telephone: +612 9796 3100
Zip Water (UK) Ltd: Trafalgar House, Rash’s Green, Dereham, Norfolk NR19
1JG UK
Telephone: +44 03456 005 005
Manufactured by:
Paragon Water Systems, Inc.; 13805 Monroes Business Park, Tampa, FL, USA.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>