ZIP PTZM600 4 In 1 5MP 18X Zoom PTZ Camera User Guide

: October 30, 2023
: Zip

Table of Contents

User Information
Connections
PTZ Control on a ZIP DVR
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

4-in-1 5MP PTZ Camera 18X Zoom
PTZM600 – Quick Start Guide

The 4-in-1 5MP PTZ Cameras incorporate a high-clarity 18x zoom camera module. The module used is a 4.7 84.6mm 5MP lens.
This unit has variable IR, as the PTZ is zoomed in, different infra-red LEDs are activated illuminating the changing angle of view. It has an IR range of 60m.
The PTZM600 default video format is in TVI mode so using the (Zip Coaxitron) protocol in the ZIP SUPA or XTRA DVR allows up the coax control, alleviating the necessity for RS485 connections.

Full Instruction Manual

www.systemq.com/PDF/manual/xPTZM600.pdf

User Information

The camera must not be exposed to conditions above the IP66 rating.
Take care when transporting, storing and installing the PTZ.
Always use and conform to current standards to install and use these. The RS-485 and video signal cables should be kept way from high voltage equipment. Damage to units by lightning or mains voltage surges is not covered under the product warranty.(BS EN 62676-1-1) (BS EN 62676-4) (BS8418)
There are no user serviceable parts in the camera and opening or attempting to repair the product will void the warranty.
Do not touch the camera connections with wet hands.
The camera working temperature outdoor is -20°C ~ +60°C and humidity must be less than 90% (frostless).
Do not aim the camera directly towards the sun or an extreme light source.
Wipe dirt away with a damp micro-fibrecloth. If needed a soapy water can be used.
Do not install or use the camera if the cables, casing of the PTZ, or the power supply is damaged.
When this unit is in use, avoid direct eye contact with the infrared lights.
Do not fit in close proximity to any flammable materials.

Connections

****ZIP SUPA and XTRA recorders have “Coaxitron” so the RS485 cables may not be required (depending on your install)

2.1mm DC Socket – 12V 2A Power supply is provided with the PTZ. If using a different PSU ensure the camera is polarity sensitive so connections must be correctly made.
4-in-1 BNC Output – Set to TVI as default. camera has a standard BNC connector for video output, the output can be changed to AHD, CVI or CVBS if required, see the full manual for more information.
Ground, RS485 +VE / -VE – When using a PTZ keyboard or if the install requires RS485 communication then use these wires.

PTZ Control on a ZIP DVR

The ZIP DVRs have coalition (COAX 1) selected for each channel which is set as default.
Note: other manufacturers may also use coaxitron communication, however this is not standardised across all CCTV DVRs, we cannot comment on the ability or inability to access or use the PTZ and any third party DVR.

To access the PTZ Control:-

Click on the image in Live view
Click on the PTZ button at the bottom of the screen.
If using a ZIP DVR with coalition then go to step 2
If using RS485 then see the steps in the Full Manual for instructions on setting the dip switches.
Mark the hole positions using the mounting bracket or using the measurements on the diagram. Drill the holes and install the wall plugs.
Feed the PTZ cable loom through the bracket, then secure using the short screws provided.
Connect cables for power, video (and RS485 if required) then fit the PTZ to the wall using the screws provided.
Remove protective film from PTZ.
Use silicon sealant around the base, where the cable enters the bracket and in the entry cut out which is not used. The connections for the camera need to be installed in a waterproof box or similar.

Camera	Image Sensor	1/ 2.8” Progressive CMOS
Resolution	5MP 2592 (H) x 1944 (V)
Lens Type	4.7mm-84.6mm (Wide-Tele)
View ing Angles	54.8°~ 3.4°(Wide – Tele)
Illumination	color: 0.05Lux/F2, B/W: 0.005Lux/F2, 0Lux( IR)
S/N	> 50dB( AGC OFF)
Digital Noise Reduction	2D DNR
BLC	On/ Off
Electronic shutter	1/25~ 1/10,000s
Optical Zoom	18x Zoom
PTZ	IR Range	60m
Pan Range	360º endless
Pan Speed	0.6°~ 180°/S
Tilt Speed	3.5°~ 30°/S
Tilt Range	0°~ 90°,auto flip 180°
Number of Presets	Maximum 220 and 32 per patrol tour
Number of Patrols / Tours	Maximum 8, each patrol can add 32 presets
Number of Patterns	Maximum 4, total record time more than 10mins
Auto Scans	360 auto scan / AB auto scan
Park Action	Presets / patrols / patterns / AB scan
General	Pow er Supply	12V DC 2A Supplied
Pow er Consumption	1.7A Max (20W)
Temperature & Humidity	-20°c-60°c,≤90%RH(frostless)
Electronic Protection	TVS3000V
IP Rating	IP66
Dimensions	249 (H) x 137 (W) x 197 (D)
Packaging Dimensions	280 x 280 x 225mm
Weight	4.0KG

All specifications are approximate. System Q Ltd reserves the right to change product specifications or features without notice. Whilst every effort is made to ensure that these instructions are complete and accurate, System Q Ltd cannot be held responsible for any losses, no matter how they arise, from errors or omissions in these instructions, or the performance or non- performance of the equipment refered to.
This symbol indicates that equipment must not be mixed with general household waste. For treatment, recovery and recycling please return to your local designated WEE/CG0783SS collection point as defined by your local council.