SANWA GMAERGW10N Ergonomic Mouse User Manual

SANWA GMAERGW10N Ergonomic Mouse

User’s Manual

YouTube

2.4G Wireless Mouse
MA.·ERGWION/IJMAEIIGWIGN
FCC ID: 2AMSUW10

2.46 Write Mouse Receiver
IANWAltC15
FCC ID: 2AMSUW10RC

FCC RULE

This equipment has been tested and found to comply with the: limits for a Class B digital device:, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not Installed and
used In accordance with the Instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular metalation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on. the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment Into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or experienced radio  technician for help

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation Is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any Interference received, Including interference that may cause undesired operation.

Opening

Thank you for purchasing this Ergonomic Mouse.

Caution

• The company is not libel for any damages, such 11.s livc motion defects, data loss, etc., caused by using this product or software. 0This product is intended for use in general workplaces and homes. The company does not assume responsibility In the event of damages caused by using in any other places.
• Refrain from using in environment!! where medical instruments and systems directly or indirectly related to human life are required, and where a high level of safety and responsibility is required.
• Refrain from using directly or indirectly with equipment and computer systems in which a high level of safety and responsibility are required.
• 00 not use this product on airplanes as it may interfere with the airplane immunization system.
• Please consult your doctor before using this product if you use a pacemaker or other medical device.

Warnings Regarding Health

• Operating the mouse, trackball, and keyboard for long periods cl time can lead to pain or numbness in hands, Shoulder etc. Serious damage may be incurred if such use i, repeated. you feel pain or numbness while operating the mouse or keyboard. stop using it immediately and consult a doctor if ~ ry. Take regular breaks from daily computer work to avoid strain on hands, arms, neck, shoulders, etc.

Specifications

Compatible models

Windows (DOS/V) PC, Apple Mac series, Chrome OS PC

• Models with a USB port (A-type connector).
• The side buttons cannot be used for the Apple Mac series.

Compatible OS

• Windows 10•8.1•8•7
• macOS 11. macOS 10.12~10.15. Mac OS X 10.6~10.11
• Chrome OS

Name of Parts

1. Left button / Right button
2. Wheel button (scroll)
3. 3 Count switch button
4. Forward button
5. Back button
6. LED7 Optical sensor system (Blue LED)
7. Power switch
8. Receiver storage slot
9. Battery cover
10. Receiver

ow to Insert Batteries

Insert the supplied AAA batteries into the battery compartment slot.
Insert the eledrode end first, then insert the body.

• Be careful of polarity when inserting batteries.

• Before using It for the first time, please make sure there Is battery power remaining.

• Replace batteries when the movement of the mouse cursor becomes rough, or when the blue LED sensor does not turn on. ‘Turn off mouse when replaclng batterfes.

• use new AAA alkaline batteries when replacing batteries.

• Leaving expired batteries In the mouse may result In leakage; be sure to remove batteries when expired.

How to Store the Receiver

Place the receiver in the receiver storage slot.

How to connect mouse

Note: It Is recommended that other applications be closed before connecting the mouse.

• Turn on the PC power and completely switch on the OS.
• Connect this product to the USB port of the PC.
• Hardware detection will begin immediately, and o wizard for updating the device driver will start up (installation is automatically completed for Mac products).

Sleep Mode

• The mouse will turn into sleep mode if not being used for a while. By clicking the mouse, it will come back to work from the sleep mode. Sometimes, however, the mouse may become unstable when suddenly being operated.
• If the mouse enters the sleep mode without the receiver connected to the computer, it will not recover from the sleep mode even if you click on it. Connect the receiver to the computer before clicking.

Customize Buttons (Windows only)

Once you download the driver software from the website, you can use the button programming function.
To use custom keystrokes, you need to keep the software enabled.

• “https://www.sanwa.com/download/mu.exe” Please access. The download will start as soon as you access it.
• Save and open the file.
• Please follow the installation wizard to install the driver.
  • In the process of installation or use of any problem, please contact us.
  • You can also refer to this document “https://www.sanwa.com/download/mu.pdf“

Troubleshooting

Q. Mouse (mouse cursor) doesn’t move.
A.

1. Make sure that the batteries have been correctly inserted. Make sure that the mouse’s power has not been switched to OFF. (see “8. How to Insert Batteries”)
2. The battery level may be low; try replacing the battery. (see “8. How to Insert Batteries”)

Q. If the mouse is not moved for some time, it takes a few moments to start up. The mouse (mouse cursor) doesn’t move.
A. If the product is not moved for some time, it enters sleep mode to conserve the battery. Pressing the button on the mouse will restore movement, but it will take a few seconds.

Q. The mouse cursor movement is not smooth.
A. Although the blue LED is a high performance sensor, there are times when the cursor does not move smoothly when used on a surface that reflects light, such as a mirror, or a transparent surface such as glass. Also, the tracking performance may degrade on regularly patterned surfaces.

Warranty Term

1 year

Inquiries
support-en@sanwa.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>