Pablo LANA LED Wall Light Installation Guide
- June 10, 2024
- Pablo
Table of Contents
Pablo LANA LED Wall Light Installation Guide
LANA MODELS
-
**WALL SM
**
-
**WALL LG
**
-
**TABLE SM
**
-
**TABLE LG
**
-
FLOOR
-
FLOOR W/ PEDESTAL
NOTE: WALL PLATE INCLUDED WITH EVERY MODEL
WALL PLATE INSTALLATION
-
IF FIXTURE IS BEING INSTALLED ONTO DRYWALL, USE PROVIDED WALL ANCHOR. TAP THE UNTHREADED TIP OF THE WALL ANCHOR INTO THE WALL, THEN USE A PHILLIPS SCREWDRIVER TO COMPLETE INSTALLATION
NOTE: IF MOUNTING ONTO WOODEN STUD, DO NOT USE WALL ANCHOR
-
A FIX WALL PLATE TO THE WALL USING THE PROVIDED W SCREW, ENSURE EDGE OF PLATE IS FLUSH WITH WALL
NOTE: WALL PLATE IS INCLUDED WITH EVERY MODEL
TABLE BASE ASSEMBLY
USE PROVIDED 3MM HEX TOOL AND 2 MACHINE SCREWS TO FIX POST TO BASE
USE PROVIDED 3MM HEX TOOL AND 3 MACHINE SCREWS TO FIX POST TO BASE
PEDESTAL INSTALLATION (OPTIONAL ACCESSORY)
-
USE THE PROVIDED SCREWDRIVER TO UNSCREW CLEAR PLASTIC SET SCREW. SLIDE PEDESTAL OVER FLOOR POST AND TIGHTEN SET SCREW UNTIL IT CONTACTS POST. PEDESTAL SHOULD SLIDE UP AND DOWN EASILY
-
SLIDE PEDESTAL TO DESIRED HEIGHT, THEN TIGHTEN KNOB TO FIX IN PLACE
SHADE INSTALLATION
MAGNETIZE SHADE TO WALL PLATE
MAGNETIZE SHADE TO TABLE OR FLOOR POST
ADJUSTMENT
SWITCH FUNCTION
TAP OPTICAL SWITCH BRIEFLY TO CYCLE THROUGH HIGH, LOW AND OFF. PRESS AND HOLD OPTICAL SWITCH TO ACTIVATE FULL RANGE DIM CONTROL. RELEASE FINGER FROM OPTICAL SWITCH WHEN DESIRED LIGHT LEVEL IS REACHED
CARE INSTRUCTIONS
WIPE CLEAN WITH A SOFT DAMP CLOTH. AVOID AMMONIA-BASED CLEANERS
- SLIDE PLUG INTO POWER SUPPLY
- ALIGN CONNECTOR/POWER SUPPLY LOCKING FEATURES
- INSERT CONNECTOR 4. TURN CONNECTOR 90 DEGREES TO LOCK
- TO REMOVE PLUG, PUSH RELEASE BUTTON AND SLIDE PLUG OUT
A. N AMERICA B. UK C. EU D. AU
NOTE: CONTACT MANUFACTURER FOR ADDITIONAL PLUG TYPE REQUIREMENTS.
INFO@PABLODESIGNS.COM
888 MARIN STREET SAN FRANCISCO, CA 94124
PABLODESIGNS.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>