STAR WATER SYSTEMS 148178 Drill Pump Instructions

STAR WATER SYSTEMS 148178 Drill Pump

Product Information

The 1/4-in Drill Pump, Model# 148178, is a utility pump designed to be used with electric hand drills. It is self-priming and can develop pressures up to 25 PSI and flow rates up to 750 GPH. The package includes one drill pump.

Product Usage Instructions

1. Attach the drill pump to an electric hand drill.
2. Insert the suction hose into the liquid you want to transfer.
3. Insert the discharge hose into the container you want to transfer the liquid into.
4. Turn on the electric hand drill to start pumping the liquid.

Safety Information

Please read and understand the entire manual before attempting to assemble, operate, or install the product. This utility pump will not turn by hand and is designed to be used with electric hand drills only. Do not operate the pump near flammable liquids or gases.

Maintenance

Regularly clean the pump after each use and store it in a dry place. If the pump fails and damages are incurred, retain possession of the pump for investigation purposes.

Warranty

Please contact our customer service department at 1-800-742-5044, Monday – Friday, 7:30 a.m. – 5:00 p.m., EST, if you have any questions or encounter any problems with your product.

MODEL# 148178

PACKAGE CONTENTS

DANGER

• FIRE/EXPLOSION HAZARD.
  Pump only clear water. Do not pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not use in a flammable and/or explosive atmosphere. Failure to follow these warnings could result in death or serious injury and/or property damage.

• RISK OF ELECTRIC SHOCK.
  Connect your drill to a properly grounded electrical outlet. For maximum safety, the drill should be connected to an outlet equipped with a ground fault interrupter device. Keep hands, feet and drill motor dry. Using or touching a wet drill motor could result in fatal electrical shock.

• CHEMICAL ALERT.
  Prop65 Warning for California residents:
  WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov

CAUTION

• PRODUCT DAMAGE MAY RESULT.
  Do not run the pump dry. Do not run pump backwards.

• PRODUCT DAMAGE MAY RESULT.
  These pumps are not designed or intended to be used to handle sewage or effluent.

• PRODUCT DAMAGE MAY RESULT.
  This pump has been evaluated for use with WATER only.

• PRODUCT DAMAGE MAY RESULT.
  Maximum continuous operating water temperature for standard model pumps must not exceed 104°F (40°C).

• PRODUCT DAMAGE MAY RESULT.
  Not designed for 24/7 operation. Design life is 4500 accumulated hours.

PRODUCT USE

This utility pump will not turn by hand. It is designed to be used with electric hand drills. It is self-priming and can develop pressures to 25 PSI and flow rates to 750 GPH.

This pump is ideal for the following applications:

• Clogged sinks
• Overflowing washing machines
• Emptying aquariums
• Pumping out pool covers
• Transferring oil from autos and boats

INSTRUCTIONS

• The inlet hose should be as short as possible and no more than 25’.
• The discharge hose should be less than 50’.
• Ensure that both hoses are free of kinks or obstructions.
• Ensure tight connections for both hoses. Rubber garden hose washers should be used to improve the seal if needed.
• Tighten the drill chuck onto the pump shaft.
• Plug in the 1300RPM or stronger drill. If using a cordless drill be sure to use a fully charged battery.
• With the pump/hose assembly loosely held with one hand and the drill with the other, slowly start the drill to ensure it is rotating in the proper direction. (See arrow on the pump housing).

MAINTENANCE

• To obtain the best pump performance and long service life, place a few drops of lubrication oil in the inlet before each use.
• When pumping fluids with abrasives or solids, use a screen or strainer on the suction line to prolong pump life.
• The pump and cover are corrosion-resistant plastic, the impeller and seal are Buna N and the shaft is stainless steel. If the pump becomes hard to turn, it may be due to chemical attack on the impeller from the pumped liquid. In this case, remove the impeller and clean with a mild soap solution.
• For longer life, flush pump with clear water after pumping chemicals or abrasives.

WARRANTY

This product is warranted for 90 days from the date of purchase. Subject to the conditions hereinafter set forth, the manufacturer will repair or replace to the original consumer, any portion of the product which proves defective due to defective materials or workmanship. This warranty does not cover replacement parts for failure due to normal wear and tear. To obtain warranty service, contact the dealer from whom the product was purchased. The manufacturer retains the sole right and option to determine whether to repair or replace defective equipment, parts or components. Damage due to conditions beyond the control of the manufacturer is not covered by this warranty.

THIS WARRANTY WILL NOT APPLY:
(a) To defects or malfunctions resulting from failure to properly install, operate or maintain the unit in accordance with printed instructions provided; (b) to failures resulting from abuse, accident or negligence or use of inappropriate chemicals or additives in the water; (c) to normal maintenance services and the parts used in connection with such service;
(d) to units which are not installed in accordance with normal applicable local codes, ordinances and good trade practices; and (e) if the unit is used for purposes other than for what it was designed and manufactured.

RETURN OF WARRANTED COMPONENTS:

Any item to be repaired or replaced under this warranty must be returned to the manufacturer at Kendallville, Indiana or such other place as the manufacturer may designate, freight prepaid.
THE WARRANTY PROVIDED HEREIN IS IN LIEU OF ALL OTHER EXPRESS WARRANTIES, AND MAY NOT BE EXTENDED OR MODIFIED BY ANYONE. ANY IMPLIED WARRANTIES SHALL BE LIMITED TO THE PERIOD
OF THE LIMITED WARRANTY AND THEREAFTER ALL SUCH IMPLIED WARRANTIES ARE DISCLAIMED AND EXCLUDED. THE MANUFACTURER SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES, SUCH
AS, BUT NOT LIMITED TO DAMAGE TO, OR LOSS
OF, OTHER PROPERTY OR EQUIPMENT, LOSS OF PROFITS, INCONVENIENCE, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES OF ANY TYPE OR NATURE. THE LIABILITY OF THE MANUFACTURER SHALL NOT EXCEED THE PRICE OF THE PRODUCT UPON WHICH SUCH LIABILITY IS BASED.
This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Some states do not allow limitations on duration of implied warranties or exclusion of incidental or consequential damages, so the above limitations may not apply to you.

In those instances where damages are incurred as a result of an alleged pump failure,the Homeowner must retain possession of the pump for investigation purposes.

Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-742-5044, 7:30 a.m. – 5:00 p.m., EST, Monday – Friday.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>