JBC CA-9QF 100V Manual-Feed Soldering Station User Manual
- June 10, 2024
- JBC
Table of Contents
JBC CA-9QF 100V Manual-Feed Soldering Station
Product Information
The CA Manual-Feed Soldering Station is available in three different variants
– CA-9QF 100V, CA-1QF 120V, and CA-2QF 230V. The product comes with a Control
Unit (CC1001) and spare parts including Circuit (0025013), Enclosure
(0023639), Tool Holder
(0014706), Splashguard (0028379), and Antisplash Membrane (CL7882). The
product also requires Fuses (T-2A for CA-9QF 100V and CA-1QF 120V, T-1A for
CA-2QF 230V) and an Earthing Fuse (F 1.25A). The product code for the Earthing
Fuse is SN5450 and the code for the Antisplash Membrane is CL7984 S0354. The
Tool Holder code is 0016351 and the Splashguard code is 0010433. The Circuit
code is 0025013 and the Enclosure code is CL6210. The product also includes
AP250-B and PLR195.
Product Usage Instructions
- Ensure that the soldering station is connected to the correct voltage power supply.
- Insert the appropriate fuse (T-2A for CA-9QF 100V and CA-1QF 120V, T-1A for CA-2QF 230V) and Earthing Fuse (F 1.25A) into the Control Unit.
- Insert the Antisplash Membrane (CL7882) into the designated slot on the Soldering Station.
- Attach the Tool Holder (0016351) and Splashguard (0010433) to the Soldering Station.
- Connect the AP250-B and PLR195 to the Soldering Station.
- Switch on the Control Unit and wait for it to heat up.
- Insert the soldering material into the Tool Holder and use it as desired.
- After use, switch off the Control Unit and allow it to cool down before storing the Soldering Station.
Parts
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>