sgreen 1669056572 Table Top Washout Booth Instruction Manual
- June 10, 2024
- sgreen
Table of Contents
sgreen 1669056572 Table Top Washout Booth Instruction Manual
Tools Required:
- Two 7/16” wrenches
- One 5/32” Hex wrench
What’s in the box
| Tag | Item | Qty. |
|---|---|---|
| 1 | MFWD-TABLEWASBDY | 1 |
| 2 | MFPB-TABLEWASHFOOT | 4 |
| 3 | MFSA-TABLEWASHDW | 1 |
| 4 | MFLS-TABLEWASHGST | 2 |
| 5 | MFCO-EDGETRIM | 7 |
| 6 | MFPB-TABLEWASHSID | 2 |
| 8 | MFPB-TABLEWASHSPCR | 1 |
Parts Required:
What’s in the box
| Tag | Item | Description | Qty. |
|---|---|---|---|
| 1 | MFPB-TABLEWASHSTOFF | Table top Washout booth Screen | 2 |
| 2 | MFCO-SGWASHCAULK | Clear Caulk, Acrylic, 5.5 oz. Tube | 1 |
| 3 | PRHD-BTN1/4NC1/2SS | 1/4-20 x 1/2 Button Head Allen | 33 |
| 4 | PRHD-WA1/4NEOBONDSS | 1/4” Neobond Stainless steel | 25 |
| 5 | PRHD-ACN1/4NCGR5ZC | 1/4-20 Acorn Nut Nickel | 33 |
| 6 | PRHD-WA1/4USSGR5ZC | 1/4” USS flat washer | 33 |
Step 1
Install the side panels (1) to the main sink body (2). Fully tighten
the hardware. Neobond washers inside of the sink and standard flat washers
outside of the sink..
Note: Refer to page 2 for hardware detail.
Step 2
Slide the rear panel on the inside of the side panel flap and align the hole
patterns to each other. You will need to place the spacer in between the rear
panel and the rear of sink before attaching the hardware.
Step 3
Install Rear panel (1) to the side panels (2) to the main sink
body. Fully tighten the hardware. Neobond washers inside of the sink and
standard flat washers outside of the sink.
Note: Refer to Page 2 for hardware detail.
Step 4
Install Legs (1) to the side panels to the main sink body (2).
Fully tighten the hardware. Neobond washers inside of the sink and standard
flat washers outside of the sink.
Note: Refer to Page 2 for hardware detail.
Step 5
Install edge trim (1) to the side panels (2) and front lip of sink
Body (3). Some trimming may be needed for this step.
Step 6
Install Gussets (1) to the side panels (2) and the rear panel (3).
Fully tighten the hardware. No Neobond washers used in this step. Finally, use
supplied caulk to seal all seams where water could leak. Allow to dry per
caulking instructions.
Note: Refer to Page 2 for hardware detail.
NOTE: Logos, graphic elements and or photo images contained in this
document may not be reproduced without the written consent of Ryonet
12303 NE 56th ST | Vancouver. WA 98662 |
360-576-7188
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>