LUX LED LIGHTING Brooklyn AURA LED Task Light User Guide
- June 4, 2024
- LUX LED LIGHTING
Table of Contents
LUX LED LIGHTING Brooklyn AURA LED Task Light
ASSEMBLY INSTRUCTIONS
- Remove Tne prorecTIVE piaSTic TiIim irom tne base or thee lamp to reveal the stabalizing pad
- Clean the infended installafion surface fo remove dust or particulates. If bottom of lamp loses its stickiness, it can be cleaned with a wet cloth.
- A tripod screw mount is also included, for a more permanent installation.
- Install the included power cord to rear of lamp and then plug into any wall outlet.
USING YOUR LUX BROOKLYN AURA LED LAMP
- Turn the light on by touching the power button on the front of the lamp.
- Press the power button again to cycle through the three brightness levels (600, 250, 20 lumens).
- The wireless Qi Charging pad will only work with Qi-enabled devices. For a full list of compatible devices, visit: https://www.wirelesspowerconsortium.com.
- NOTE : The wireless charger will generally charge any compatible mobile device provided the case is no thicker than 3mm. However, if the back panel is thicker, or if the case contains a battery, cards, or other metal, it may prevent the device from wirelessly charging.
- When using the lamp to charge your devices, unplug or remove the devices once batteries are full.
SAFETY INFORMATION
- The flexible external power supply cable cannot be replaced; if the cable is damaged the entire power supply must be replaced.
- For indoor Use only; do nof use Oufdoors or in damp locations.
- Switch the lamp off before disconnecting the power.
- Do not look directly at the LEDS when they are illuminated.
OVERVIEW
FCC STATMENT
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation of the device.
Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the quipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
References
- LUX makes high quality LED lights for hotels, homes, and workspaces. – LUX LED Lighting
- wirelesspowerconsortium.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>