Shenzhen Yongdongke Innovation Technology Co Ltd NQWB02 Magnetic Power Bank User Guide

Yong dongke Innovation Technology Co Ltd NQWB02 Magnetic Power Bank
User Guide

Magnetic Power Bank
QUICK START GUIDE

Function  introduction

Working Modes of power bank

a . Charging for 1 device
b. Charging for 2 devices at the same time

c. Charging for 3 devices at the same time
‘Important Note: The type ¢ will be off when the phone wireless charger and watch wireless charger are at working.        

Product specification

Magnetic Wireless Power Bank

Customer Service

30 days no-reason refund, 12 months limited
warrantly and lifetime Technical Support
For any questions, Please feel free to contact us via BowPin123@l63.com

Manufacturer

Manufacturer:
Shenzhen Yong dongke Innovation Technology Co., Ltd.
Address: 3-B03, Building A, Qingchuang City, Zhangkeng Complex, Minzhi Street, Longhua District, Shenzhen,China
Bowpin Service Email: BowPin123@163.com
Bowpin After-sales Service
Email: BowPin123@163.com

Important Safety Instructions

When using this product, basic precautions should always be followed, including the following:

• Do not store the product in a hot or humid environment
• Do not disassemble the product. Take it to a qualified
• Do not disassemble the product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or injury to persons. • Do not dispose of the product in heat or fire.
• Do not clean the product with harmful chemicals or detergents.
• Misuse, dropping, or excessive force may cause product damage.
• When disposing of secondary cells of batteries, keep cells or batteries of different electro chemical systems separate from each other.
• Be aware that discharged battery may cause fire or smoke, tape the terminals to insulate them.

Warning

FCC This device complies with part 15 of the FCC Rules. Operations are subject to the following two conditions:

1. This device may not cause harmful interference
2. this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device under part 15 of the FCC Rules. These limits are designed to protect reasonably against harmful interference in a residential installation. This equipment generates and uses can radiate radio frequency energy, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio / TV technician for help.
CAUTION: To comply with the limits of the Class B digital device, under Part 15 of the FCC Rules, this device must be used with certified peripherals and shielded cables. All peripherals must be shielded and grounded. Operation with non-certified peripherals or non-shielded cables may result in interference to radio or reception.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
NQ-WB-02-V1.0

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>