BRT Systems LDSBus USB Adapter User Guide

June 10, 2024
BRT Systems

BRT Systems LDSBus USB Adapter User Guide
BRT Systems LDSBus USB Adapter User Guide

Setup Instructions:

The LDSBus USB Adapter serves two functions: 1) Configure LDSBus Devices 2) Create an LDSBus

To Configure LDSBus Device (Sensors/Actuators)

Step 1 : Connect the LDSBus USB Adapter to a PC with a USB-C to USB-A (or USB-C to USB-C) cable.
Step 2: Ensure that the LDSBus Device is connected to its cable at one end
Step 3: Attach the other end of the cable to the LDSBus USB Adapter as shown.
Step 4; Scan the QR code or visit the link provided below to download the LDSBus Configuration Utility and obtain step by step instructions for configuration.
Connation

To Create an LDSBus2) To Create an LDSBus

Step 1 : Connect the LDSBus USB Adapter to a USB Host. (Windows/Linux PC, RPi3/4, or other supported hosts)
Step 2 : Connect a 24VDC/18W power adapter to theDC jack and power on. (Power to the LDSBus will be enabled by software)
Step 3: Connect the first LDSBus HVT-Junction to the LDSBus USB Adapter using a RJ45 (CAT5e) Cable
Step 4: If there is more than one LDSBus HVTJunction, chain them together as shown.
Connation

Note: Enable termination for last LDS Bus Device in the bus using the LDS Bus Configuration Utility Please scan QR code A or visit http://bit.ly /system-warranty for warranty registration using the UUID and Product Key
QR code
View the full information of the LDS Bus USB Adapter, application setup and installation at http://bit.ly/ldsbus-resources or scan QR Code B.

BRT Systems LDSBus USB Adapter User Guide

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals