LEDOne LOC-8RDUT-22WMCCT Fuel Range Round Ultra Thin LED Panel Installation Guide

: June 10, 2024
: LEDone

Table of Contents

SAFETY INSTRUCTIONS
CAUTION: Risk of fire
CLEANING & MAINTENANCE
INSTALLATION
COLOR TEMPERATURE SELECTION
COMPATIBLE DIMMER LIST
CUSTOMER SUPPORT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LEDOne LOC-8RDUT-22WMCCT Fuel Range Round Ultra Thin LED Panel

LEDOne LOC-8RDUT-22WMCCT Fuel Range Round Ultra Thin LED
Panel

SAFETY INSTRUCTIONS

Read instructions carefully before attempting to install fixture.

Fixture must be wired in accordance with the National Electrical Code and all applicable local codes.
Proper grounding is required for safety.
This product must be installed in accordance with the applicable installations code by a person familiar with the construction and operation of the product and the hazards involved.

CAUTION: Risk of fire

Risk of electrical shock! Disconnect power before installing or servicing.
To prevent early lamp failure, lamp should only be installed in operating environments ranging between -20°C and +40°C (-4 °F and +104°F).
No user serviceable parts inside. To avoid electrical shock, do NOT disassemble the product.
WARNING: Risk of fire or electric shock, installation requires knowledge of luminaires electrical systems. If not qualified, do NOT attempt installation. Contact a qualified electrician.
Do NOT make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING: To prevent wiring damage or abrasion, do NOT expose wiring to edges of sheet metal or other sharp objects.
Installers should NOT disconnect existing wires from lamp holder terminals to make new components at lamp holder terminals. Instead, installers should cut existing lamp holder leads away from the lamp holder and make new electrical connections to the lamp holder lead wires by employing applicable connectors.
WARNING: Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
The fixture is accepted as a component of a luminaire where the suitability of the combination shall be determined by CSA or authorities having jurisdiction.
The recessed luminaire is intended for mounting only in a covered ceiling (where only the LED side of the luminaire will be exposed to damp or dry locations).

CLEANING & MAINTENANCE

CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.

Clean frosted polystyrene lens and fixture with non-abrasive cleaning solution.
Do NOT open fixture to clean the LEDs. Do NOT touch the LEDs.

Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during installation, operation or maintenance.

INSTALLATION

Turn the power OFF.
If needed, cut a round hole based on the size you are installing. (Fig. 1)
Open the junction box cover and carefully remove the appropriate knock out(s) with a screwdriver or punch. (Fig. 2)
Make the wiring connections inside the junction box per the electrical connections section. (Fig. 3)
Select the desired color temperature using the dip switch on the side of the junction box. (Fig. 4)
Squeeze the 2 torsion clips so that they are in an upright position and insert the fixture into the ceiling hold. Once the fixture is inside the ceiling, release the housing clips and continue pushing the fixture into the ceiling hole until securely fixed and flush with the ceiling. (Fig. 5)
Turn on the circuit breaker and test the light.

COLOR TEMPERATURE SELECTION

Select the color temperature by adjusting the switch to the desired color temperature on the side of the junction box.
CCT Options: 2,700K / 3,000K / 3,500K / 4,000K / 5,000K

Color Temperature Selection