Futaba T16IZ SUPER Radion Air Transmitter Instruction Manual
- June 10, 2024
- Futaba
Table of Contents
Futaba T16IZ SUPER Radion Air Transmitter Instruction Manual
Connection T16IZ/T16IZ SUPER and GYA553
CAUTION
Be sure to connect and disconnect the GYA553 and Transmitter connection cable
with the power off.
SETTING
-
Select “Gyro setting” on the last page of Airplane Model Menu
-
Select “Start”
-
Home screen is displayed
When copying data from Gyro A to Gyro B
Connect the gyro A to the transmitter and press [Start]. (Enter the data of A
into transmitter)
Connect Gyro B to transmitter and press [GY Settings Transfer]. (Put data on A
into gyro B)
Home screen
On the home screen, basic information such as gyro operation mode,
sensitivity, battery voltage are displayed.
Basic menu
Config
Config 1/7 Gyro set mounting direction
Set the mounting direction of GYA. Set mounting direction withh reference to figure below.
Config 1/7 WING/TAIL
Config 1/7 Servo type
Select the servo type according to the servo to be used.
Digital servo → DG : 285 Hz
Analog servo → AN : 70 Hz
Config 1/7 SB/R2 OUT
Config 2/7 Gyro direction
It is the direction settting of the gyro. Be careful as it will crash if the direction is reversed. For dual aileron, dual elevator, and dual rudder aircraft, check the operating direction of each second aileron/elevator/rudder.
Config 3/7 Neutral offset
Config 4/7 5/7 Servo limit
This is the limit setting for each servo. The position of the maximum
operation is read into the gyro in the first setting.
If the SB/R2 port output is set to “S.BUS(HS)” or “S.BUS(STD)”, the setting
menu will display AIL3 and AIL4 setting items.
Aileron example
Stick to full right
Adjust the value (%) to reach the maximum operating position
Stick to full left
Maximum angle Adjust the value (%) to reach the
Config 6/7 Holding Power
Decreasing the value weakens the holding power and makes the operation feeling closer to the normal mode.
The current rate numbers C1 to C5 are displayed by operating the channel of the transmitter. between them. You can set the holding power rate selector switch to the channel with the AFR function of the transmitter, and set the point for each rate on the AFR point curve to switch. It is also possible to use
Display and adjust the current rate numbers C1 to C5 by operating the channel on the transmitter.
When set to SW of DG1 or DG2
When set to dial or lever
Config 7/7 Reset
Reset each Config item. It returns to the initial value.
SBUS Basic menu
Set the CH for each function according to the transmitter to be used. Any unused functions should be set to INH (Inhibited).
CH setting items for AIL3 and AIL4 are displayed on the signal is output to the corresponding CH of the S.BUS output.
- Match the operation CH and CH setting on the function setting screen on the transmitter side.
- When the AIL3 and AIL4 CH settings are INH, the gyro control is not performed and the data sent from the transmitter is output as is.
WARNING
Always verify that the S.BUS function assignments match your transmitterʼ s
function (in the FUNCTION menu) assignments. If any changes are made within
the transmitter function assignments, then it will also be necessary to make
the changes within the S.BUS function assignments. To change the channel,
GYA553 and T16IZ must be connected.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>