LEDone LOC-RDCP Multi Watt Multi CCT Series Installation Guide

LEDone LOC-RDCP Multi Watt Multi CCT Series

SAFETY INSTRUCTIONS

Read instructions carefully before attempting to install fixture.

• All wiring should be performed by a qualified electrician.
• Disconnect power before installing or servicing. This fixture must be wired in accordance with the National Electrical Code and applicable local codes and ordinances.
• Proper grounding is required to ensure personal safety.
• This fixture is for outdoor use and should not be used in areas with limited ventilation or high ambient temperatures.

CAUTION: Risk of fire

• WARNING: Make certain power is OFF before installing or maintaining the fixture. No user-serviceable parts inside.

CLEANING & MAINTENANCE:

CAUTION: Be sure the fixture temperature is cool enough to touch. Do NOT clean or maintain while the fixture is energized.

1.  Clean lens with non-abrasive cleaning solution.
2.  Do NOT open fixture to clean the LED. Do NOT touch the LED.
   Note: These instructions do not cover all details or variation in equipment, nor do they provide for every possible situation during installation, operation or maintenance.

WIRING
Universal voltage driver permits operation at 120V through 277V, 50/60Hz except fixtures the factory ordered with a (PC).

1.  Connect the BLACK fixture lead to the (+) LINE supply lead.
2.  Connect the WHITE fixture lead to the (-) COMMON supply lead.
3.  Connect the GREEN fixture lead to the supply ground

0-10V DIMMABLE WIRING

Universal voltage driver permits operation at 120V through 277V, 50/60Hz. For 0-10V dimming, follow the wiring instructions in the figure below.

1.  Connect the BLACK fixture lead to the (+) LINE supply lead.
2.  Connect the WHITE fixture lead to the (-) COMMON supply lead.
3.  Connect the GROUND wire from fixture to supply ground. DO NOT connect the GROUND of the dimming fixture to the output.
4.  Connect the PURPLE fixture lead to the (V+) DIM lead.
5.  Connect the PINK or GRAY fixture lead to the (V-) DIM lead.
6.  The driver comes with dimmable leads. If it is unused, make sure the leads are properly capped (if applicable).

WATTAGE AND CCT ADJUSTABLE TABLE SWITCH SETTING

(Only for models with wattage and CCT adjustable functions.)

LOC-RDCP-MW(40/50/60/75)MCCT(30/40/50)DLV

Wattage Options      CCT Options

• 40W                             3,000K
• 50W                             4,000K
• 60W                             5,000K
• 75W

INSTALLATION OPTIONS

Canopy Mounting or Pendant Mounting

CANOPY MOUNTING:

1.  Install the mounting plate to a sturdy mounting surface.
2.  Tighten the 4 screws. The safety harness MUST be connected onto 1 of the screws.
3.  Connect the wires properly.
4.  Slide the fixture horizontally into the 2 card slots of the mounting plate.
5.  Tighten the 2 screws on the fixture side.

PENDANT MOUNTING

(not included)

1.  Feed the fixture wires through the pendant pipe.
2.  Mount the pendant pipe into the top nut of the fixture.

References

• Energy Saving with LED Lighting Fixtures & Bulbs | LED One Corporation

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>