renkforce 2626369 2.4 GHz Wireless Presenter and Laser Pointer Instruction Manual

Operating Instructions
2.4 GHz Wireless Presenter and Laser Pointer
Item no: 2626369 www.conrad.com/downloads

Intended use

The product is a wireless presenter with laser pointer. Use the product as a pointing device during presentations and to control sideshows. It is battery operated and works with a USB-A receiver that fits into a magnetic slot when not in use.
The product is intended for indoor use only. Do not use it outdoors.
Contact with moisture must be avoided under all circumstances.
If you use the product for purposes other than those described, the product may be damaged.
Improper use can result in short circuits, fires, or other hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the product.
Read the operating instructions carefully and store them in a safe place. Make this product available to third parties only together with the operating instructions.
All company names and product names are trademarks of their respective owners. All rights reserved.

Delivery contents

• Product
• USB-A receiver (inside battery compartment)
• 1x AAA battery
• Laser warning signs in different languages
• Operating instructions

Latest product information

Download the latest product information at www.conrad.com/downloads or scan the QR code shown. Follow the instructions on the website.

Description of symbols

The symbol warns of hazards that can lead to personal injury.

Safety instructions

Read the operating instructions carefully and especially observe the safety information. If you do not follow the safety instructions and information on proper handling, we assume no liability for any resulting personal injury or damage to property. Such cases will invalidate the warranty/guarantee.
5.1 General

• The product is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing material for children.
• If you have questions which remain unanswered by this information product, contact our technical support service or other technical personnel.
• Maintenance, modifications and repairs must only be completed by a technician or an authorised repair centre.

5.2 Handling

• Handle the product carefully. Jolts, impacts or a fall even from a low height can damage the product.

5.3 Operating environment

• Do not place the product under any mechanical stress.
• Protect the appliance from extreme temperatures, strong jolts, flammable gases, steam and solvents.
• Protect the product from high humidity and moisture.
• Protect the product from direct sunlight.

5.4 Operation

• Consult an expert when in doubt about the operation, safety or connection of the product.
• If it is no longer possible to operate the product safely, take it out of operation and protect it from any accidental use. DO NOT attempt to repair the product yourself. Safe operation can no longer be guaranteed if the product:
  – is visibly damaged,
  – is no longer working properly,
  – has been stored for extended periods in poor ambient conditions or
  – has been subjected to any serious transport-related stresses.

5.5 Batteries

• Correct polarity must be observed while inserting batteries.
• The batteries should be removed from the device if it is not used for a long period of time to avoid damage through leaking. Leaking or damaged batteries might cause acid burns when in contact with skin, therefore use suitable protective gloves to handle corrupted batteries.
• Batteries must be kept out of reach of children. Do not leave batteries lying around, as there is risk, that children or pets swallow them.
• Batteries must not be dismantled, short-circuited or thrown into fire. Never recharge non-rechargeable batteries. There is a risk of explosion!

5.6 Laser class 2

• When operating the laser equipment, always make sure that the laser beam is directed so that no one is in the projection area and that unintentionally reflected beams (e.g., from reflective objects) cannot be directed into areas where people are present.

• Laser radiation can be dangerous if the laser beam or its reflection enters unprotected eyes. Before using the product, familiarise yourself with the statutory regulations and instructions for operating this type of laser device.

• Never look into the laser beam or point it at people or animals. Laser radiation can seriously damage your eyes.

• If laser radiation enters your eyes, close your eyes immediately and move your head away from the beam.

• If your eyes have been irritated by laser radiation, do not continue to carry out tasks with safety implications, such as working with machines, working from heights, or working close to high voltages. Do not drive any vehicles until the irritation has completely subsided.

• Do not point the laser beam at mirrors or other reflective surfaces. The uncontrolled, reflected beam may strike people or animals.

• Never open the device. Configuration or maintenance tasks must only be completed by a trained specialist who is familiar with the potential hazards. Improper maintenance work may result in dangerous laser radiation.

• The product is equipped with a class 2 laser. Laser signs in different languages are included in the packaging. If the sign on the laser is not in your local language, attach the appropriate sign to the laser.
  Max. Output: <1 mW
  Wavelength: 630/670 nm
  EN 60825-1: 2014

• Caution: Using equipment or procedures other than those described in these instructions could lead to exposure to dangerous radiation.

Product overview

Note:
The following information is applicable to Microsoft Power Point. Features and functions with other applications may differ.

Installing and replacing the battery

1. Remove the battery compartment cover.
2. Insert a battery matching the polarity shown inside.
3. Replace the battery compartment cover.

Connection

1. Insert the receiver into an available port on your computer.
2. Wait a few moments for your computer to download the necessary drivers and setup your new device.
   → The product is now ready for use.

Tip:
(If needed) press the CONNECT button to rebuild the connection between the presenter and receiver.

Operation

Preconditions:
The receiver is connected, and you are within wireless range.

1. Switch the main power switch ON.
2. Load your presentation software and open the file you will present.
3. Press and hold the “UP” button to enter presentation mode.
4. Press the “UP” or “DOWN” buttons to change slides.
5. Switch the main power switch OFF after use.

Tip:
For further information about various functions, refer to the table in section: Product overview [ ► 3]

Cleaning and care

Important:
– Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions. They damage the housing and can cause the product to malfunction.
– Do not immerse the product in water.

1. Clean the product with a dry, fibre-free cloth.

Declaration of Conformity (DOC)

Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau hereby declares that this product conforms to the 2014/53/EU directive.

• Click on the following link to read the full text of the EU declaration of conformity: www.conrad.com/downloads

Enter the product item number in the search box. You can then download the EU declaration of conformity in the available languages.

Disposal

12.1 Product
This symbol must appear on any electrical and electronic equipment placed on the EU market. This symbol indicates that this device should not be disposed of as unsorted municipal waste at the end of its service life.
Owners of WEEE (Waste from Electrical and Electronic Equipment) shall dispose of it separately from unsorted municipal waste. Spent batteries and accumulators, which are not enclosed by the WEEE, as well as lamps that can be removed from the WEEE in a non-destructive manner, must be removed by end users from the WEEE in a non-destructive manner before it is handed over to a collection point.
Distributors of electrical and electronic equipment are legally obliged to provide free take-back of waste.
Conrad provides the following return options free of charge (more details on our website):

• in our Conrad offices
• at the Conrad collection points
• at the collection points of public waste management authorities or the collection points set up by manufacturers or distributors within the meaning of the ElektroG

End users are responsible for deleting personal data from the WEEE to be disposed of.
It should be noted that different obligations about the return or recycling of WEEE may apply in countries outside of Germany.
12.2 (Rechargeable) batteries
Remove batteries/rechargeable batteries, if any, and dispose of them separately from the product. According to the Battery Directive, end users are legally obliged to return all spent batteries/rechargeable batteries; they must not be disposed of in the normal household waste.
Batteries/rechargeable batteries containing hazardous substances are labelled with this symbol to indicate that disposal in household waste is forbidden. The abbreviations for heavy metals in batteries are: Cd = Cadmium, Hg = Mercury, Pb = Lead (name on (rechargeable) batteries, e.g. below the trash icon on the left).
Used (rechargeable) batteries can be returned to collection points in your municipality, our stores or wherever (rechargeable) batteries are sold. You thus fulfil your statutory obligations and contribute to environmental protection.
Batteries/rechargeable batteries that are disposed of should be protected against short circuit and their exposed terminals should be covered completely with insulating tape before disposal. Even empty batteries/rechargeable batteries can contain residual energy that may cause them to swell, burst, catch fire or explode in the event of a short circuit.

Technical data

13.1 Product
Power supply …………………………………… 1x 1.5 V AAA battery
Material…………………………………………… ABS
Receiver …………………………………………. USB-A, plug and play
Dimensions (W x H x D) ……………………. approx. 106 x 39 x 27 mm
Weight ……………………………………………. 40 g
13.2 Wireless module
Wireless frequency ………………………….. 2.402 – 2.480 GHz
Wireless range ………………………………… 15 m
Wireless transmission power …………….. 12.68 dBm
13.3 Laser
Class………………………………………………. 2
Range …………………………………………….. 50 m
Wavelength……………………………………… 650 nm
Colour …………………………………………….. red
13.4 Supported OS
OS …………………………………………………. Windows® XP, Vista, 7, 8, 10, MacOS, Linux
13.5 Application support
Applications …………………………………….. Word, Excel, PowerPoint. ACDSee, Acrobat Reader
13.6 Environment
Operating conditions…………………………. 0 to +50 °C, 10 – 90 % RH (non-condensing)
Storage conditions……………………………. -20 to +70 °C, 5 – 95 % RH (non-condensing)
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method (e.g. photocopying, microfilming or the capture in electronic data processing systems) requires prior written approval from the editor. Reprinting, also in part, is prohibited.
This publication reflects the technical status at the time of printing.

Copyright by Conrad Electronic SE.
*2626369_V2_0523_dh_mh_en
9007200037907467-2 I2/O2 en

References

• Conrad Electronic » All parts of success
• Conrad Electronic » All parts of success
• Download center

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>