Beko HNT61630X Cooker Hood User Manual

Beko HNT61630X Cooker Hood User Manual

Please read this user manual first!

Dear Valued Customer,

Thank you for preferring this Beko appliance. We hope that you get the best results from your appliance which has been manufactured with high quality and state-of- the-art technology. For this reason, please read this entire user manual and all other accompanying documents carefully before using the appliance and keep it as a reference for future use. If you handover the appliance to someone else, give the user manual as well. Follow the instructions by paying attention to all the information and warnings in the user manual.

Remember that this user manual may also apply to other models. Differences between models are explicitly described in the manual.

Meanings of the Symbols

Following symbols are used in various sections of this user manual:

General safety

Important Safety Instructions Read Carefully And Keep For Future Reference This section contains safety instructions that will help protect from risk of fire, electric shock, exposure to leak micro- wave energy, personal injury or property damage. Failure to follow these instructions shall void any warranty.

• Beko products comply with the applicable safety standards; therefore, in case of any damage on the appliance or power cable, it should be repaired or replaced by the dealer, service center or a specialist and authorized service alike to avoid any danger. Faulty or unqualified repair work may be dangerous and cause risk to the

• This appliance is intended to be used in household and similar applications such as:

  • Staff kitchen areas in shops, offices and other working en- vironments;
  • Farm houses

• By clients in hotels, and other residential type environments;

• Bed and Breakfast type envi-

• Operate the appliance for its intended purpose only as de- scribed in this manual.

• The manufacturer cannot be held liable for damages resulting from improper installation or misuse of the

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental ca- pabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards

• Children shall not be allowed play with the Cleaning and user maintenance shall not be made by children without su- pervision.

• The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of your product must be at least 65 cm.

• If the instructions for installation for the gas hob specify a greater distance, this has to be taken into

• Make sure that your mains power supply complies with the information supplied on the rat- ing plate of the

• Never use the appliance if the power cable or the appliance it- self is damaged.

• Prevent damage to the power cable by not squeezing, bending, or rubbing it on sharp edges. Keep the power cable away from hot surfaces and naked

• Use the appliance with a grounded outlet

WARNING: Do not connect the appliance to the mains until the installation is fully complete.

• Place the appliance in a way so that the plug is always

• Do not touch the lamps if they have operated for a long time. They can burn your hands since they will be

• Follow the regulations set out by competent authorities on dis- charge of the exhaust air (this warning is not applicable for use without flue).

• Operate your appliance after put- ting a pot, pan etc. on the hob. Otherwise, high heat may cause deformation in some parts of your

• Turn off the hob before taking the pot, pan from it.

• Do not leave hot oil on the hob. Pans with hot oil may cause self

• Pay attention to your curtains and covers since oil may catch fire while cooking food such as

• Grease filter must be cleaned at least monthly. Carbon filter must be replaced at least every 3

• Product shall be cleaned ac- cordance with user manual. If cleaning was not carried out in accordance with user manual, there may be fire

• Do not use non-fire-resistant filtering materials instead of the current

• Only use the original parts parts recommended by the man- ufacturer.

• Do not operate the product with- out the filter and do not remove the filters while the product is

• In the event of be started any flame, de-energize your product and cooking

• In the event of be started any flame, cover the flame and never use water to

• Unplug the appliance before each cleaning and when the ap- pliance is not in

• The negative pressure in the envi- ronment should not exceed 4 Pa (4×10 bar) while the hood for elec- tric hob and appliances running on another type of energy but electric- ity operate

• In the environment where the appliance is being used, the ex- haust of devices running on fuel oil or gas, such as room heater must be absolutely isolated or device must be hermetical

• When connecting the flue, use pipes with a diameter of 120 or 150 Pipe connection must

be as short as possible and have as few elbows as possible.

• Danger of choking! Keep all the packaging materials away from

CAUTION: Accessible parts may become hot when used with cook- ing appliances.

• The product outlet must not be connected to air channels that include other
• The ventilation in the room may be insufficient when the hood for electric hob is used simultane- ously with the devices operating on gas or other fuels (this may not apply to appliances that only discharge the air back into the room).
• Objects placed on the product may fall. Do not place any ob- jects on the
• Do not flambe under the your

WARNING: Before installing the Hood, remove the protective films.

• Never leave high naked flames under the hood when it is in op- eration
• Deep fat fryers must be contin- uously monitored during use: overheated oil can burst into flames.

Compliance with the WEEE Directive and Disposing of the Waste Product:

This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equip- ment (WEEE).
This symbol indicates that this product shall not be disposed with other household wastes at the end of its ser- vice life. Used device must be returned to offical collection point for recycling
of electrical and electronic devices. To find these collection systems please contact to your local au- thorities or retailer where the product was pu- chased. Each household performs important role in recovering and recycling of old appliance. Appropriate disposal of used appliance helps pre- vent potential negative consequences for the envi- ronment and human health.

Compliance with RoHS Directive

The product you have purchased complies with EU RoHS Directive (2011/65/EU). It does not contain harmful and prohibited materials specified in the Directive.

Package Information

Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Do not dis-
pose of the packaging materials together with the domestic or other wastes. Take them to the pack-

General appearance

Overview

1. Body
2. Control panel
3. Grease filter
4. Lighting

Technical data

Operation of the appliance

Controlling the appliance

Energy efficient usage

• When using your appliance, adjust the speed settings according to vapour and odour intensity, in order to save

• Use low speeds (1, 2) under normal conditions, and high speed (3) for intense odour and

• The lamps on the hood are placed for illuminat- ing the cooking

• Using them for environmental lighting shall cause unnecessary energy expenditure and in- sufficient

• For your device to consume less energy, run it at a low speed

• Your device will reduce energy consumption as it will run more efficiently when you provide suf- ficient air intake to it.

• Set your device to the intense suction power level before the formation of steam, in cases where you know that the dense steam will occur. So, you reduce energy consumption by using your device for a shorter time as it will have a sufficient air

• Keep the lids of the cookware closed to reduce the steam

Operation of the hood

• Your appliance contains a motor that has various
• For better performance, we recommend using low speeds under normal conditions and high speeds in cases of strong odours and intense
• You can start your appliance by pressing on the desired speed setting (A, B, D)
• You can illuminate the cooking area by pressing the lamp (E).

Cleaning time for the metal filter

Filters must be cleaned when the signal “c” is dis- played on the screen or (depending on the use) after 3 or 4 weeks. In order to clear the “c” signal, after the filters have been cleaned and replaced, press and hold the button (A) for more than 3 sec- onds (when the device is turned off). the letter “e” will appear on the screen, and the appliance will operate normally. if operations are necessary be- fore clearing the letter “c”, then the active engine speed will appear for 1 second when you press the (A) button and then the engine will resume functioning.

Operation of the appliance

Replacement of lamp

Bulb|
---|---
Bulb power| 3 W
Holder/Socket| GZ 10
Bulb voltage| 220 – 240 V
Size| 53 x 50 mm
ILCOS code| DR/F-3-220-240- GZ10-50-53
Luminous flux| 260 lm
Correlated colour temperature| 3000 K

This product contains a light source of energy ef- ficiency class “F”.

Operation with chimney connection

• Vapour is extracted through the flue duct, which is fastened to the connection head on the

Cleaing and maintenance

The device should be cleaned and maintained regularly. Failure to keep the device clean will adversely affect the service life of the device. For cleaning and maintenance, follow the instructions stated in the manual.

| Non-compliance with the provisions associated with the cleaning of the device and replacement of the filters may result in a risk of fire. Therefore, it is recommended to follow the guidelines stated here. The manufac- turer is not responsible for the engine damages or fires originating from the improper use.

Cleaning of the grease filter

Grease filter retains the oil particles in the air. Grease filters may change colour after repeated cleaning. This is normal and does not require re- placement of filters.

1. External grease filter
2. Internal grease Filter
   • Pull the sliding plate out by holding the front Remove the external grease filter first, and then the internal grease filter.
   • Push the grease filter lock
   • Then lower it slightly down and pull it Oth-

erwise, you can bend the filter. Wash and rinse grease filters with liquid detergent and replace grease filters to their sockets by by carrying out the steps specified above in reverse order. This filter retain the oil particles in the air.

Replacement of carbon filters

Odour removing filters contain charcoal (Active carbon). Grease filters must be installed in the product, regardless of whether or not carbon fil- ters are used.

• Remove the grease
• To remove the carbon filter, remove the car- bon filter from its housing by rotating it coun- ter-clockwise from the
• Install the new carbon filter. Install the grease filter

Installation of appliance

A| WARNING: Before starting the in- stallation, read the safety informa- tion on User Manual.
---|---
B| WARNING: Failure to install with screws and stabilizers in accordance with these instructions may result in electric shock.
---|---

For the installation of the hood, please contact the nearest Authorized Service.
It is the customer’s responsibility to prepare the location and electrical installation of the hood.

Position of the appliance

• Distance between the cooker and the cooker hood must be considered prior to assembly. This distance should be 65
• Distance must be measured from the surface of grate for gas cookers,
• From surface of glass for electric

Drilling the hanging holes

Paste the installation template provided with the product on the surface where the product is to be installed.
Drill holes with the diameter of 04 mm on the points marked A, B, C, D on the arrangement scheme (Fig. 1).

Tighten the exhaust vent of the specified tube in the installation template to the given dimensions

The equipment will be installed on the housing in points A, B, C, D using the 4 x 40 screws supplied with the equipment. Do not rub the front panel against the housing case when the sliding set is moving (Fig. 2).

Installation of appliance

If necessary, insert the 0150/120 mm tube adapt- er at the tube outlet (Fig. 3)

5.1  Installing and unpacking the appliance

• check whether the appliance presents
• Any faults caused by transport should be imme- diately reported to the courier
• Visible faults must also be communicated to the
• Do not allow children to play with the packaging material!!!

Storage

• If you do not intend to use the appliance for a long time, please store it
• Please make sure that the appliance is un- plugged, cooled down and totally
• Store the appliance in a cool and dry
• Keep the appliance out of the reach of children

Handling and transportation

• During handling and transportation, carry the appliance in its original packaging. The packag- ing of the appliance protects it against physical
• Do not place heavy loads on the appliance or the The appliance may be damaged.

Dropping the appliance will render it non-opera- tional or cause permanent

Troubleshooting

restore it.
Appliance is not working.| Check the electrical connection.| Mains voltage shall be between 220 and 240 V.
Appliance is not working.| Check the electrical connection.| Check if other appliance in your kitchen operate.
Illumination light does not operate.| Check the electrical connection.| Mains voltage shall be between 220 and 240 V.
Illumination light does not operate.| Inspect the lamp switch.| Lamp switch shall be at “on” position.
Illumination light does not operate.| Inspect the lamps.| The lamps of the appliance shall illuminate.
Air inlet of the appliance is inadequate.| Inspect the grease filter.| Under normal operating conditions, grease filter shall be cleaned at least once in a month.
Air inlet of the appliance is inadequate.| Check the air discharge flue.| The air discharge flue shall be at “on” position.
Air inlet of the appliance is inadequate.| Inspect the carbon filter.| The filters of the appliances with carbon filters shall be replaced once in every 3 months under normal conditions.

Read More About This Manual & Download PDF:

References

• Arctic Romania - Electrocasnice pentru intreaga familie
• Beko Global
• Beko Romania - Electrocasnice cu Tehnologii Ingenioase

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>