AFINIA H440 3D Printer User Guide

: June 11, 2024
: AFINIA

Table of Contents

H440 3D Printer
Machine Structure
Unboxing
Software and Connect Printer
Install Filament Spool
Load and Print Models
WIFI Setup Guide
Documents / Resources

H440 3D Printer
User Guide

H440 3D Printer

Visit “ www.afinia.com/support/manuals- guides/ ” to download the latest user manuals.
WARNING: This 3D printer – when used with styrene filament (ABS / HIPS / PC-ABS) – can expose you and others in the same room to styrene, a chemical known to the State of California to cause cancer. www.P65Warnings.ca.gov
ALWAYS OPERATE THIS PRODUCT IN A WELL-VENTILATED AREA.

Machine Structure

AFINIA H440 3D Printer - Machine Structure

Unboxing

Open the package and remove the printer and accessories. Remove the foams and zip tights in the machine. Check whether the accessories are complete.
Insert the filament spool holder into the spool bracket on the back of the machine.

Software and Connect Printer

Download the operation software Afinia Studio 2.X from https://www.afinia.com/support/downloads/choose-product/ and install it on your computer.
Turn on the power switch at the back of the printer.
Install the print plate, close the top lidand close the front door.
Perform an automatic Calibration.① Click the Initialize button to initialize the printer. ② Click the calibration button to enter the nozzle calibration interface. ③ Click the Auto button to start the automatic nozzle height calibration.

Install Filament Spool

Put one spool of filament on the spool holder Ⅰ① at the back of the printer.
\ Pull one end of the filament, feed the
ment through the filament feeding system ② on the upper right at the back of the printer, and pull the filament close to the extruder.
In the “Material” interface of the touchscreen, click the material button in the circle switching among different types of Filaments. Choose the filament that you would like to use.
After material selection, click the Extrude button in the Material interface. The nozzle starts being heated, and the heating progress will be displayed on the upper left of the status bar.
Gently press the end of the filament into the extruder inlet and push it to the end. When the temperature of the nozzle reaches the preset temperature, the printer will beep and the extruder will automatically grab the filament, and pull it in and extrude it through the nozzle.

Load and Print Models

Connect the printer to a computer via USB. Connect the power cord and turn on the power switch on the back of the printer.
Start the Afinia Studio2.X software. One the top area, the software shows the Serial Number of the machine, nozzle temperature, print bed temperature, and material type.
Click the “Build” button on the main menu to open the print interface, then click to load the STL.
Use the Print Navigator to adjust the 3D model.
Click the “Print” button and set print parameters.
Click “Print” to start transferring the model data to the printer. Once the transmission finishes, the software will prompt the estimated printing time and material consumption. At this time, the printer can be disconnected from the computer.
After the data transmission is completed, the nozzle starts to heat up, and the model starts to print after the nozzle reaches the system set temperature.

WIFI Setup Guide

Click the“Config”button.
Make sure the Wi-Fi option is “ON”, then click the Wi-Fi button in the upper right corner.
Click the search button on the top right corner, and search for Wi-Fi.
In the network list, choose the Wi-Fi network that your computer is on.
Click the Password field to enter a Wi-Fi password.
Input the password, then press “return”.
Click the “Connect” button to finish. If successful, the disconnected Wifi icon on the top status bar will change to connected.
Users can turn the toggle button “Private” on and set a password for the printer to prevent unauthorized access to the printer.