TOURATECH 01-046-0631-0 Bar Ends Alu For Yamaha XT1200Z Super Tenere Up To 2013 Instruction Manual
- June 11, 2024
- Touratech
Table of Contents
TOURATECH 01-046-0631-0 Bar Ends Alu For Yamaha XT1200Z Super Tenere Up
To 2013
We recommend having the accessory parts fitted by a specialist workshop.
Important Safety Instruction
-
These instructions are written based on our current state of knowledge. Information is provided without any guarantee as to its accuracy. Subject to technical
modifications. -
The order of assembly steps must be followed.
-
Touratech accepts no liability for incorrectly fitted parts and resulting material damage or personal injury!
-
Please observe applicable road vehicle (construction and use) regulations as well as EC/ECE Directives and applicable laws in your country. If parts are fitted which
require inspection and/or approval after fitting, take your vehicle to a testing station immediately and have the vehicle papers updated. -
Check and if necessary tighten all bolted connections after 50 km.
-
Standard tightening torques in Nm for bolted connections with strength class 8.8.
-
For special tightening torques refer to your specialist workshop!
-
Please take into account that fitting panniers, crash bars, foot peg lowering kits (rider and pillion), Kickstand enlargement plates, front spoilers, and engine guards may restrict the bike’s lean angle!
-
If modifications are made to the fairing, stem, handlebar, fairing parts, etc., ensure that electrical wiring, brake lines, accelerator, and clutch cables are refitted correctly.
-
Check clearance, on both sides with a full steering lock.
-
Always disconnect the battery when working on the electrics!
-
We recommend cutting the protective film to size and applying it to impact areas that are likely to be chipped by stones.
-
Work on the brake system and suspension should always be carried out by a specialist workshop.
-
The maximum load on luggage racks is 5 kg! Luggage racks Zega Pro TC is 10 kg!
-
If other original accessories or aftermarket accessories are used, ensure clearance1 fitment and do not come into contact with other parts!
-
Apply conventional lubricant to stainless steel bolts prior to assembly.
-
PDF fitting instructions also can be downloaded from the Touratech webshop.
Symbols
- Caution
- Note
- Warning
- Liquid
- Torque
- Template
- 2 Persons
- Original motorcycle part
Specification
Mounting instructions
© January, 2023 by:
Touratech GmbH, Germany