CO2METER COM CM-7000 CO2 Multi Sensor System User Guide
- June 11, 2024
- CO2METER COM
Table of Contents
CO2METER COM CM-7000 CO2 Multi Sensor System User Guide
Step 1.
Using the email provided by CO2Meter, click on the “download the file” button
to download the CM-7000 series firmware file.
Step 2.
Once downloaded, Plug an empty flash drive into the computer.
Step 3.
Go to where you saved the file, named ‘v7-multidrop.apk’ and move it to the
flash drive. DO NOT RENAME THE FILE
Step 4.
*WARNING! Please ensure this file name displays EXACTLY:
“v7-multidrop.apk”.
Step 5.
Next, safely remove/eject the flash drive from your computer
Step 6.
Plug the flash drive into the bottom of the tablet in the USB port. The update
should begin automatically after a couple of seconds.
Step 7.
Wait for the update to finish installing (this install should not take more
than 1 minute).
Step 8.
You will see an alert pop up that says “Unfortunately, Multidrop has stopped.”
[This is supposed to happen]. Press ‘OK’ to finish.
Step 9.
On the tablet screen wait for the firmware to finish updating and press the
‘settings’ gear in the top right corner.
Step 10.
Scroll all the way to the bottom of the screen and it should read “Version
v2.2.23” This means your tablet has been updated!
PLEASE NOTE
FORPROPERUPDATE YOU MUST FOLLOW BOTHPAGE 1AND2 INSTRUCTIONS.
Please Note: Depending upon your CM-7000 series configuration, you will need to repeat steps 1-6 for EACH sensor
Step 1.
From the home page of the CM-7005 tablet, press on any of the “sensor circles”
to go to the sensor detail page.
Step 2.
Press on the lock icon in the top right corner and enter the password:
‘co2meter’ to unlock the sensor settings.
(The settings will remain unlocked for 5 min)
Step 3.
Press the ‘UPDATE SENSOR’ button.
Step 4.
A prompt will come up asking if you are sure you would like to soft reset your
sensor.
Step 5.
Press “YES”.
Step 6.
Press the ‘DONE’ button to go back to the home page.
Step 7.
To verify the update was successful: go into the same “sensor circle” and look
to see that the version number (located above the sensor name) has changed to
v1.1.7.
Congratulations!
This means your sensor(s) and tablet have all been updated!
FOR ADDITIONAL SUPPORT CONTACT:
SUPPORT2@CO2METER.COM
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>