PREMIER AUTOPARTS S2 TRM Motor Vehicle Tire Pressure Monitor System Installation Guide
- June 11, 2024
- PREMIER AUTOPARTS
Table of Contents
AUTOPARTS S2 TRM Motor Vehicle Tire Pressure
Monitor System **Installation Guide**
INSTALLATION GUIDE
FOR PRE-PROGRAMMED TPMS SENSOR
S2 TRM Motor Vehicle Tire Pressure Monitor System
WARNING
Read all instructions and warnings before installing. Professional
Installation Only. Failure to follow installation guide may result in the
failure of the motor vehicle Tire Pressure Monitor System (“TPMS”) sensor to
operate properly.
CAUTION
- This TPMS sensor assemblies are replacement or maintenance parts for motor vehicles that have a factory installed TPMS only.
- Pre-Programmed sensor ,works like an OE sensor.
- Works with all major TPMS scan tools for relearn process.
- Upon completion of installation, test the motor vehicle TPMS using procedures described in the original manufacture? s service guide to confirm proper installation. If fails to operate, immediately consult with a trained motor vehicle dealership.
WARRANTY
TPMS sensor complies with product specifi-cations and shall be free from
defects in workmanship and material for a period of Twenty-four (24) months or
30,000km after the sale of product to the customer, whichever comes first.
The warranty shall be void if any of the following occurs:
- Improper installation of products
- Improper usage
- Induction of defect by other products
- Mishandling of products
- Incorrect application
- Damage due to collision or tire failure
- Damage due to racing or competition
- Exceeding specific limits of the product
This is the sole and exclusive warranty and liability to customer. We disclaim
any other warranty including the warranties of merchantability, fitness for
purpose or other implied or express warranties.
Under no circumstances shall we be liable to customer for any other amounts
including labor charges for installation of products, nor shall we be liable
under any theory for any other damages ,including but not limited to direct,
indirect, special, consequential, and incidental damages.
INSTALLATION GUIDE
Apply tire soap or lube solution to the rubber valve stem. Line the sensor up
with rim hole and attach a standard mooting tool to the end of the valve. Pull
the valve stem straight through the valve hole. Make sure the valve and rim
hole should be concentric. Place the tire on the rim, make sure that the valve
faces the separation head at an angle of 180°. Mount the tire over the rim.
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, macaques harmful interference to radio communications. However,
there is no guarantee that-interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly
approved by manufacturer could void your authority to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.