Jiangyin Premier Autoparts Industry S1 TPMS Sensor Instructions
- June 6, 2024
- Jiangyin Premier Autoparts Industry
Table of Contents
General programmable sensor instructions
Before installing the sensor, be sure to read the installation instructions carefully and operate according to the requirements:
- Do not use sensors with damaged appearance;
- The installation process should be operated by trained professionals according to the guidance requirements;
- The warranty period is 12 months or 20000 km, whichever comes first
Screw、Shell、Valve、Valve, Cap
Product Name: TPMS Sensor
working voltage:3V
Emission current:6.7MA
Air pressure range:0-5.8Bar
Air pressure accuracy:±0.1Bar
Temperature accuracy:±3℃
working temperature:-40℃-105℃
working frequency:433.92MHZ/315MHZ
Product weight:21.8g
Operation steps:
- Before the sensor is installed, it should be programmed with a tool according to the model year;
- Install it on the wheel hub according to the following figure: Select the direction suitable for the angle and screw on the air nozzle nut
Keep the white surface of the sensor parallel to the wheel hub surface, and tighten the air nozzle nut with 8nm torque Tire power balance
Installation precautions:
- The valve should not extend out of the rim
- The sensor shell shall not interfere with the wheel rim
- The white surface of the sensor shall be parallel to the rim surface
- 。 The sensor housing must not extend beyond the rim flange
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Caution: Changes or
modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
‐ Reorient or relocate the receiving antenna.
‐ Increase the separation between the equipment and receiver.
‐ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help with an
important announcement
RF Exposure Information
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
a minimum distance of 20cm between the radiator and your body.