XQ VehicalX1 Toy RC Car Instruction Manual

XQ VehicalX1 Toy RC Car Instruction Manual

Thank you for choosing our toy R/C car. To ensure correct and pleasing operations, please read through the following use instruction and have enough understanding of the product before use.

CAUTION:

• ELECTRICALLY OPERA TED PRODUCT
  Not recommended for children under 8 years of age. As with all electric products, precautions should be observed during handling and use to prevent electric shock.

• ADULT SUPERVISION REQUIRED.
  Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Contents : VehicleX1 Transmitter controller X1

Transmitter & Vehicle Operation

Operations Tips :

• Please make sure the power switch is in the ON position when you operate, and OFF position when not in use.
• If the car direction goes left, please adjust Steering alignment Lever to right until the car goes straight.
• If the car direction goes right, please adjust Steering alignment Lever to left until the car goes straight.

Battery and Antenna Installation- Transmitter and Vehicle

1. Install one AA battery with polarity(+/-) as shown inside batter compartment.
2. Follow the arrowhead to close the remote control’s battery cover.
3. Install AA batteries inside the battery compartment.
4. Tighten battery door with a Philips head screwdriver.

How To Play?

1. Install “AA” batteries inside the battery compartment that is underneath the chassis, taking care to observe the polarity. Fit back the cover.
2. Insert AA battery inside the controller. The car is now ready to run.
3. Turn the two switches located on both the car and the controller to the “ON” position and then operate the car.
4. If the car does not run in a straight line adjust the steering alignment lever located beneath the chassis.
5. When the light in the controller begins to dim, it may be time to replace the AA battery.
6. When your R/C model car begins to lose performance, power or function, it may be time to replace the “AA” batteries.

Battery Performance Note

For best performance, use alkaline batteries. Battery life will vary according to brand.

Battery Safety Information

1. Don’t mix old and new batteries. Always replace all batteries at the same time.
2. Don’t mix batteries of different types.(Alkaline, standard batteries or rechargeable batteries).
3. Insert the “AA” batteries with their polarity(+/-) as shown inside the battery compartment.
4. Don’t short-circuit terminals.
5. Don’t recharge non-rechargeable batteries. Rechargeable batteries may only be charged under the supervision of an adult.
6. Remove all batteries if vehicle will not be used for a long period of time.
7. Dispose of batteries safely. Don’t dispose of batteries in fire as they may explode.
8. Exhausted batteries are to be removed from the toy.
9. Keep these instructions for future reference: they contain important information.
10. Packaging has to be kept since it contains important information.
11. Rechargeable batteries are to be removed from the toy before being charged.

Care & Maintenance

1. Always remove batteries from the toy when it is not being used for a long period of time.
2. Wipe the toy gently with a clean damp cloth.
3. Keep the toy away from direct sunlight and/or direct heat.
4. Do not submerge the toy into water that can damage the electronic assemblies.

© GuangDong Xin Yu Technology Industrial Co., Ltd.
For more information, visit www.xq-toys.com
Made in China

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions : (1) this device may not cause harm full interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Warning : Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE : This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures :

• Reorient or relocate the receiving antenna.
• Increase the separation be tween the equipment and receiver .
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected .
• Consult the dealer or an experienced radio /TV technician for help

The device must not be co-located or operating in conjunction with any other antenna or transmitter.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>