MORRIS H2164HD Wall Mounted Hair Dryer Instruction Manual

: June 11, 2024
: MORRIS

Table of Contents

H2164HD Wall Mounted Hair Dryer
Product Information: Wall Mounted Hair Dryer
Product Usage Instructions

H2164HD Wall Mounted Hair Dryer

MORRIS-H2164HD-Wall-Mounted-Hair-Dryer -PRODUCT-IMAGE

Product Information: Wall Mounted Hair Dryer

The Hotel Series Wall Mounted Hair Dryer Model H2164HD is a hair dryer designed for use in bathrooms. It has a universal shaver socket and a hair dryer on/off switch. The appliance can be used by children over 8 years of age and by individuals with limited physical, sensory or mental abilities, provided they are suitably supervised or have been educated to use the appliance safely and fully understand the associated risks.

The installation of a residual current device (RCD) with a rate residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom for additional protection. The electrical system should be fitted with a device that guarantees omnipolar disconnection from the electricity mains under category III overvoltage conditions. The hair dryer must be Fixed so that a person taking a bath or shower cannot reach the handle when the cord is at maximum extension.

Product Usage Instructions

Assembly and Operating Instructions:

Read the instructions thoroughly before use.
Ensure that the electrical system is fitted with a device that guarantees omnipolar disconnection from the electricity mains under category III overvoltage conditions.
Make sure the unit is perfectly dry before using it.
Do not use the appliance near bathtubs, showers, basins, or other vessels containing water.
The hair dryer must be fixed so that a person taking a bath or shower cannot reach the handle when the cord is at maximum extension.
Allow your appliance to cool before storing it away, and do not wrap the supply cord around the hair dryer in storage.

Installation Instructions:

The installation of the wall holder should be carried out by a suitably qualified electrical engineer to comply with the existing national safety regulations.
Before installing the hair dryer, always switch off the general switch of your mains electricity.
Separate the cover (1) of the wall holder from the back plate by loosening the screw (2) according to picture 1.
Drill four holes with 6mm diameter according to picture 2.
Put the toggle inside the holes, place the base onto the wall and secure with screws.
Secure the front cover with the screw (2).
Switch on the general switch of your mains electricity. The hair dryer is ready for use.

Instructions for Use:

The control switch on the wall holder turns the hair dryer on and off.
The pushbutton turns the hair dryer on and off, and air speed can be adjusted to low, medium, or high.

Product Care:

When not in use, the mains switch on the wall holder should be in the off position.
Clean the appliance with a cloth dampened with water. Do not use detergents, solvents, alcohol, or other chemical products.
Clean the air inlet grill with a soft brush or a vacuum cleaner when necessary.

Notice About Recycling:
The product complies with the requirements of several directives. The detailed declaration of conformity can be found at www.morris.gr

ASSEMBLY AND OPERATING INSTRUCTIONS

Read these instructions thoroughly.

CAUTION

For additional protection, the installation of a residual current device (RCD) having a rated residual operating current not exceeding 30mA is advisable in the electrical circuit supplying the bathroom. Ask your installer
for advice.
Make sure the electrical system is fitted with a device which guarantees omnipolar disconnection from the electricity mains under category III overvoltage conditions.
Make sure the unit is perfectly dry before using it.
WARNING: Do not use this appliance near bathtubs, showers, basins or other vessels containing water.
This hair dryer must be fixed so that a person taking a bath or shower cannot reach the handle, when the cord is at maximum extension.
This appliance can be used by children from 8 years of age and over, and by persons with limited physical, sensory or mental abilities or who lack the relevant experience and knowledge, if they are suitably supervised or have been educated to use the appliance safely and fully understand the associated risks.
Do not allow children to play with the appliance. Children must not perform cleaning and maintenance procedures unless supervised.
Do not use your unit if it is not working properly. Do not try to repair this electrical unit yourself, rather contact an authorized technician. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly qualified person in order to avoid a hazard.
Plug the hair dryer into an alternating current outlet only, and make sure that the voltage of your electricity supply is the same as that indicated on the rating plate of the appliance.
Do not immerse the unit in water or other liquids.
Never put the appliance in a place where it could fall into water or in other liquids.
Do not try to salvage an electrical appliance which has fallen into water.
Turn the unit off when you put it down.
Unplug the appliance when not in use, but never do it by pulling the cord.
Remember to check regularly that the air inlet and outlet grills are clean.
Allow your appliance to cool before storing away and do not wrap the supply cord around the hair dryer in storage.

INSTALLATION INSTRUCTIONS

This is a model with universal shaver socket and hair dryer on/off switch. A safety transformer insulates the shaver socket from the mains and a protection device inhibits the operation of the appliance with a load higher than 20VA.

Installation of wall holder
This work should only be carried out by a suitably qualified electrical engineer, in order to comply with the existing national safety regulations. The hair dryer should be positioned in a place where it could not be reached by a person using the bath or the shower when the spiral cord is extended to its maximum length.
Attention: before installing the hair dryer always switch off the general switch of your mains electricity.

Separate the cover (1) of the wall holder from the back plate by loosening the screw (2) according to picture 1.
Drill four holes with 6mm’diameter according to picture 2.
All measures are in mm
Put the toggle inside the holes, place the base onto the wall and secure with the screws.
Secure the front cover with the screw (2).
Switch on the general switch of your mains electricity.
The hair dryer is ready for use.

INSTRUCTIONS FOR USE

Control Switches

Control switch on wall holder 0-1 = Off/On

Hairdryer
Pushbutton: ON=On/Off (pressure must be maintained to operate the hairdryer)

C = Low air speed
1 = Medium air speed
2 = High air speed

PRODUCT CARE
When not in use, the mains switch on the wall holder should be in the “Off” position.
You can clean your appliance with a cloth dampened with water.
The cleaning of hair dryers with detergents, solvents, alcohol and other chemical products is strictly prohibited.
When necessary, the air inlet grill should be cleaned with a soft brush or a vacuum cleaner.

NOTICE ABOUT RECYCLING

Your product is designed and manufactured with high quality materials and components which can be recycled and reused. This symbol means that electrical and electronic equipment, at their end-of-life,
should be disposed of separately from your household waste. Please dispose of this equipment at your local community waste collection/ recycling centre.
In the European Union there are separate collection systems for used electrical and electronic products.
Please help us to conserve the environment we live in!

DECLARATION OF CONFORMITY

Herewith, Amiridis – Savvidis S.A. states that this product, complies with the requirements of below directives:
EMC-Directive: 14 / 30 / EU
Low Voltage Directive: 14/ 35 / EU
ErP Directive 09 / 125 / EC
CE Marking: 93 / 68 / EEC
RoHS Directive: 11 / 65 / EU & 15 / 863 / EU
The detailed declaration of conformity can be found at www.morris.gr
Exclusive importer in Greece:
Amiridis – Savvidis S.A.
87A, 17th Noemvriou str, P.C. 55534
Thessaloniki – Greece
T: +302316006600 | F: +302316006650
www.amiridis-savvidis.gr