CLATRONIC HM 3524 Hand Mixer User Manual
- June 11, 2024
- CLATRONIC
Table of Contents
- CLATRONIC HM 3524 Hand Mixer
- Product Information
- General Information
- Assembly / Disassembly
- Electrical Connection
- Using the Blender
- Cleaning
- Storage
- Special Safety Precautions for this Device
- Intended Use
- Location of Controls
- Assembly/disassembly
- Electric operation
- Cleaning
- Accessories
- Technical Specifications
- Disposal
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
CLATRONIC HM 3524 Hand Mixer
Product Information
This user manual provides information and instructions for using the product. The product is an electric hand blender with a mix stick, dough hooks, and beaters for mixing and blending food ingredients. The blender has a turbo mode and multiple speed settings to adjust the blending intensity. It also has safety mechanisms to prevent accidental injury during use.
Product Usage Instructions
General Information
Before using the product, ensure all packaging materials, such as plastic bags, cardboard, and Styrofoam, are removed from the product. Keep packaging materials out of reach of children to avoid suffocation hazards. Also, be careful when handling the sharp blades of the mix stick during cleaning.
Assembly / Disassembly
Do not attempt to bypass safety mechanisms that prevent the simultaneous mounting of the mix stick with the dough hooks or beaters. To assemble or disassemble the product:
- Slide the protective cover aside to expose the socket.
- Insert the appropriate tool (mix stick, dough hook, or beater) into the socket and secure it in place.
- To remove the tool, press the release button and pull it out of the socket.
Electrical Connection
Ensure that the switch is set to “0” before plugging in the blender. To turn on the blender, move the switch to the desired speed setting.
Using the Blender
When using the mix stick, speed settings are disabled to prevent accidents. Use turbo mode for brief intervals (up to 1 minute) for best results. Refer to the table below for recommended maximum quantities and tool usage:
Maximum Quantity | Tool Usage | Turbo Mode | Max. Operating Time |
---|---|---|---|
500 g | Dough Hooks | N/A | 5 min. |
750 g | Beaters | Turbo | 5 min. |
1 liter | Mix Stick | Turbo | 1 min. |
Cleaning
Be careful when cleaning the sharp blades of the mix stick. Do not immerse the shaft of the mix stick in the water to prevent water from entering the shaft.
Storage
Store the product in a safe and dry place after use. cribed and let it dry completely. · We recommend that you store the appliance in the original packaging, should you not want to use it for a longer period of time. · Always store the appliance out of the reach of children in a well-ventilated and dry location.
General Notes
Before using this device, carefully read this user manual and keep it together
with the Warranty Certificate, cashier receipt and if possible, the original
package inclusive its interior packing. If you hand on the device to any third
person, include the user manual as well.
- Use the device for private and its intended purpose only. The device is not intended for commercial use.
- Do not use the device outdoors. Protect it from heat, direct sunlight, humidity (do not immerse into liquids under any circumstances) and sharp edges. Do not use the device with wet hands. If the device gets wet, unplug it immediately.
- Always switch off and unplug the device (pull the plug, not the cable) when you do not use the device, or when you attach accessories, during cleaning or malfunctioning.
- Do not leave the device unattended during operation. Always switch off the device when leaving the room. Unplug the device.
- Regularly check the device and cable for signs of damage.
- Do not continue to operate the device in case of damage.
- Do only use the original parts.
- For the safety of your children, keep any packing parts (plastic bags, cartilage, Styrofoam etc.) out of their reach.
WARNING
Don’t let small children play with foils for the danger of suffocation!
Special Safety Precautions for this Device
WARNING: Risk of injury!
- Switch off and disconnect the appliance from the mains before changing accessories.
- The knife of the blender stick is very sharp. Therefore use extreme caution when handling this part!
- Do not touch moving parts. Always wait until such parts have come to a complete stop.
- Spoons, dough scrapers or similar objects must not be in the container during operation.
- Make sure to keep long hair away from the appliance during operation.
- Always disconnect the appliance from the supply if it is left unattended and before assembling, disassembling or cleaning.
WARNING: Risk of injury
- Do not repair the device by yourself. Please contact authorized personnel.
- In order to avoid hazards, a damaged mains cable must be replaced with an equivalent cable by the manufacturer, our customer service or any other qualified specialist.
- This appliance shall not be used by children.
- Keep the appliance and its cord out of reach of children.
- Children shall not play with the appliance.
- Appliances can be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and if they understand the hazards involved.
- This device must not be immersed in water for cleaning. Please follow the instructions provided in the chapter “Cleaning”.
Intended Use
This appliance is intended for mixing, stirring, beating, pureeing or cutting food. It is suitable for processing common household quantities. It is only designed for this use and should only be used for this intended purpose. Only use this device as instructed in this user manual. Do not use this device commercially. No other use is intended and can cause damage or personal injuries. The manufacturer is not responsible for any damages incurred due to improper use.
Location of Controls
- Eject button for dough hooks and beaters
- Switch
- On/Off switch
- Switch for speed settings 1 to 5
- TURBO button
- Blender stick
- Knife
- Fixture with cover for attaching the blender stick
- Beaters
- Dough hooks
- Ring marking
Unpack Device
- Take the device out of its packaging.
- Remove all packaging materials, such as foils, filling materials, cable ties and cartons.
- Check that all accessories are included in the box.
- If the contents of the box are incomplete or if damage is found, do not operate the appliance. Return it to the dealer immediately.
NOTE:
Clean manufacturing residues and dust from the device as described under
“Cleaning”.
Assembly/disassembly
CAUTION:
Safety mechanisms prevent the simultaneous assembly of the blender stick and
the dough hooks/beaters. Do not try to bypass them!
Assembly of dough hooks/beaters
NOTE
- For safety reasons, the fixtures for the dough hooks/beaters will lock once the blender stick is attached.
- The dough hook and the beater with the ring marking on their shaft must only be attached to the larger fitting of the mixer. The other dough hook and beater are intended for the smaller fitting. The two dough hooks and the two beaters must not be attached without following these instructions.
- Make sure the switch (2) is at the “0” position and the appliance is disconnected from the mains.
- Push the ends of the dough hooks or beaters into the respective fittings until they lock into place. Slightly turning the accessories might help facilitate the process of attaching.
Disassembly of dough hooks/beaters
Press the release button (1) to release the accessories. This is only possible
when the switch is set to the “0” position or the blender stick symbol.
Assembly of the blender stick
NOTE
- For safety reasons, the blender stick cannot be used once the dough hooks or beaters are attached.
- The fixture for attaching the blender stick (6) is located on the bottom of the appliance.
- Make sure that the switch is set to the “0” position and that the appliance is disconnected from the mains.
- Slide the protective cover open in order to expose the fixture.
- Push the blender stick (4) into the fixture until it rests completely. Lock the blender stick by turning it counterclockwise as far as it will go.
Disassembly of the blender stick
In order to release the blender stick from the housing, turn it clockwise and
pull it off.
Instructions for use
- For best results, use high-quality containers that are not too big.
- In order to avoid splashing, submerge the dough hooks or beaters into the food to be mixed before switching on the appliance.
- Start with a low-speed setting (1 – 2) and then select a higher setting if necessary.
- After switching off the appliance, wait until the motor comes to a complete stop before removing the dough hooks or beaters from the food.
- The appliance is suitable for small quantities only! Fill containers with the maximum quantities only as indicated in the table!
Blender stick
CAUTION
Do not use the blender stick for cutting hard foodstuffs such as coffee beans,
nutmeg or ice cubes. This could damage the product.
- Cut larger size ingredients into smaller pieces (max. Ø 1.5 cm) and add some liquid before pureeing.
- Do not exceed the MAX marking when submerging the blender stick into the bowl with ingredients.
Electric operation
- Make sure the switch is at the “0” position.
- Before you plug the mains plug into the outlet, check whether the system voltage that you want to use, matches the one of the appliances. You will find information about it on the type plate.
- Connect the appliance to a correctly installed grounded outlet.
Switch (2)
Turning on/off
Using the dough hooks and beaters
- In order to switch on the appliance, set the switch to one of the positions from “1” to “5”.
- When at the “0” position, the appliance is switched off.
Using the blender stick
- Set the switch to the blender stick symbol.
- Press the TURBO button (3).
- When releasing the button, the appliance will stop.
- Set the switch to the “0” position.
NOTE
When assembling the blender stick, a safety switch will deactivate the speed
settings.
Turbo operating mode
All speed settings allow you to temporarily switch to the highest speed
setting. In order to do so, press the TURBO button during operation. When
activating the button in short intervals, you will achieve a pulse operation.
CAUTION: Short-term operation
- In speed setting modes 1 to 5, the maximum operating time of 5 minutes per operating cycle must not be exceeded.
- When using the blender stick, the operating time per operating cycle is only 1 minute.
- Wait at least 10 minutes between two operating cycles
Please choose the accessories and speed setting according to the table below
Product/method of preparation| Max. quantity| Accessories|
Speed setting / Button| Max. operating time
---|---|---|---|---
Heavy dough (e.g. yeast dough)| 500 g| Dough hooks| 1 – 4| 5 min.
Cake batter or light crêpes mixture| 750 g| Beaters| 2 – 5| 5 min.
Sponge mixture, waffle mixture, cream| 750 g| Beaters| 2 – 5| 5 min.
Liquids, e.g. dressings, milkshakes| 1 Liter| Beaters| 2 – 5| 5 min.
Blender stick| TURBO| 1 min.
Fruit| | Blender stick| TURBO| 1 min.
Onions, herbs| | Blender stick| TURBO| 1 min.
Ending operation
- Set the switch to the “0” position and wait until the motor has come to a complete stop.
- Disconnect the plug from the outlet.
- Detach the accessories from the housing and clean them immediately.
Cleaning
WARNING
- Always remove the power cord before cleaning.
- Do not immerse the appliance in water for cleaning. It could result in an electric shock or fir.
CAUTION
- Do not use a wire brush or other abrasive utensils for cleaning.
- Do not use aggressive or abrasive cleaning agents.
- Immediately clean the appliance after each use.
- Only use a damp cloth for cleaning the housing.
- Dough residue sticking to the main cable can be removed with a cloth as well.
Accessories
WARNING: Risk of injury!
The knife of the blender stick is very sharp. Handle with care.
CAUTION
Do not immerse the blender stick shaft completely in the water. Make sure no
water enters the shaft while cleaning it.
- Rinse the blender stick under warm running water. Leave it in an upright position afterward for water that might have entered to run off.
- Clean the dough hooks and beaters in warm soapy water. They are dishwasher-safe. Make sure not to overdose on cleaning agents.
- Dry all parts thoroughly after cleaning.
Storage
- Clean the appliance as described and let it dry completely.
- We recommend that you store the appliance in the original packaging, should you not want to use it for a longer period of time.
- Always store the appliance out of the reach of children in a well-ventilated and dry location.
Noise development
The sound pressure level in the ear of an operator (LpA) was measured
according to DIN EN ISO 3744. Sound pressure level detected: approx. 83 dB(A)
(no limit).
Technical Specifications
- Model: …………………………………………………………………..HM 3524
- Power supply:………………………………………220-240 V~, 50/60 Hz
- Power consumption: ……………………………………………………………………………………………..300 W
- Protection class: ………………………………………………………………………………………. II
- Short-term operation: ………………………………………………………………………………………………..5 minutes
- Turbo operating mode: ……………………………………………………………………1 minute
- Net weight: ………………………………………………….. approx. 1.20 kg
The right to make technical and design modifications in the course of continuous product development remains reserved. This device complies with all current CE directives, such as electromagnetic compatibility and low voltage directive and is manufactured according to the latest safety regulations.
Disposal
Meaning of the “Wheelie Bin” Symbol
Take care of our environment, do not dispose of electrical appliances via
household waste. Dispose of obsolete or defective electrical appliances via
municipal collection points. Please help to avoid potential environmental and
health impacts through improper waste disposal. You contribute to recycling
and other forms of utilization of old electric and electronic appliances. Your
municipality provides you with information about collecting points.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>