ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film Installation Guide

June 11, 2024
ACF Greenhouses

Solawrap UV Greenhouse Bubble Plastic Film
Installation Guide

Solawrap UV Greenhouse Bubble Plastic Film

In order to have a good installation the following tips are recommended:

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film -
Dimention

  • Measure your bow spacings- the distance between the supports.

  • You should be at 4,5,6 feet or 2 meter spacing. If this is not the case, please make adjustments to the bows or add additional purlins to make this possible. (Call us we are here to help and give you options).

  • Unevenly spaced bows make your vertical installation difficult, but not impossible. (Again, just give us a ring).

  • Measure your longest length run needed. This is how much material will be required for your structure. Please keep in mind that you can not successfully seam the material without loss of structural strength.

  • Rolls are sold either in custom lengths or as master rolls, which are ~300 feet in length.
    **Please note that the first wrap around a master roll is not part of this count, it is given as additional protection during shipping, if your first layer is damaged, not to worry! It is not calculated in your material request.ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - master
rolls

  • Install tracks into your frame with self-taping screws (stainless or galvanized is recommended) 1 ¼” to 1 ½” length. Insert the Solawrap film into the tracks.

***Optional for Warmer Climates: It is suggested that a neoprene washer to added to the screw at the assembly to help spread the load and prevent the screw from heating up and melting through the extrusion. Screw spacing recommendation is 12” -24” apart depending on the wind, rain, and snow loads. For low snow load areas, 17” spacing is adequate. In high wind and snow loads, 12” spacing is recommend.

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - Warmer
Climates

Tracking must be aligned properly or film could get damaged when inserted.
After correct alignment is achieved, seal the joint with weather UV resistant silicone.

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - correct
alignment

Where the film first enters the extrusion tracking, we recommend that the ends are terminated in a manner to round the sharp corners to prevent cutting as the material slides into place.

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - Figure
1

Film Insertion:
Lubricate the channels using soapy water or WD-40 /silicone spray.

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - Figure
2Using a flat strip, either additional extrusion or old wiggle wire track you sandwich the film down creating a tight seal.
End Walls:

ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - Figure
3

**** When installing the film, put the thick side to the sun. If you feel the film, there is a distinct difference in the film thickness. Thick side out. The underside is coated with an anti-condensation coating.

Tools and Equipment Needed For Solawrap Installation:

  • Sharp cutter/blade

  • Measuring tape

  • Marker

  • Self-taping screws (stainless or galvanized is recommended) 1 1/4-1 1/2“in length.
    ***Optional for warmer climates it is suggested that a neoprene washer be added to the screw at assembly to help spread the load, and prevent the screw from heating up and melting through the extrusion.

  • Ladders, and or scissor lifts

  • Drill or impact driver with 5/16 bit, or one of your choosing

  • Saw

  • 2 work horses and a bar (at a minimum 1 foot longer than your film size.

  • Clear silicone, outdoor and waterproof (used for the connections between your extrusions.

  • Chanel lubricant, WD-40, soapy water etc.ACF Greenhouses Solawrap UV Greenhouse Bubble Plastic Film - Figure 4

Do you have SolaWrap Greenhouse Installation questions?
By Phone Toll Free In the U.S. 866 597 9298
By Phone directly: 760 597 9298
By Fax: 760 597 9574

Scan Code With Smart PhoneACF Greenhouses Solawrap UV Greenhouse Bubble
Plastic Film - Qr Codehttps://qrco.de/bcXcvq

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals