ACROMA 3 x Max 60W Candelabra Base Instruction Manual
- June 12, 2024
- ACROMA
Table of Contents
ACROMA 3 x Max 60W Candelabra Base
Product Information
This product is a lighting fixture designed for installation in indoor spaces. It requires a power supply and can accommodate up to three candelabra base bulbs with a maximum wattage of 60W each. The fixture comes with a mounting plate, support screws, outlet box screws, hex nuts, finials, green ground screw, wire connectors, flat center rod, and beads.
Product Usage Instructions
- Before starting the installation, read all the instructions provided.
- Place the product on a soft, non-abrasive surface like carpet or cardboard to prevent damage.
- Ensure you have the necessary tools for installation: Phillips screwdriver, safety goggles, wire stripper, electrical tape, and pliers. These tools are not included with the product.
- Prioritize safety by disconnecting the power before installation. This can be done by turning off the circuit breaker, removing the fuse at the fuse box, or tripping the breaker that controls the circuit. It is recommended to tape a sign to the panel warning others to leave the circuit alone while you work.
- If you have any electrical questions during installation, consult a qualified electrician. For non-electrical questions about the fixture, contact customer service through the distributor where you purchased the product.
- Assembly of the fixture involves the following steps:
- Determine the length of stem or chain required for hanging the fixture.
- Attach the mounting plate to the junction box.
- Make all necessary electrical connections by following the wiring instructions provided.
- Hang the fixture from the ceiling using the appropriate hardware.
- Install the bulbs (bulbs not included) into the candelabra base sockets.
- Read the wiring and grounding instructions carefully, along with any additional directions provided. Make sure to turn off the power supply during installation. If new wiring is needed, consult a qualified electrician or local authorities to ensure compliance
with code requirements.
Safety lnformation
READ AND SAVE THESE INSTRUCTIONS
- For your protection and safety,carefully read and understand the information provided in this manual completely before attempting to assemble,install,or operate this product.Failure to do so could lead to electrical shock,fire,or other injuries that could be hazardous or even fatal.
- Before touching any wire,use a voltage tester to make sure it not live.
- When replacing fuses,turn off the main power firs.Make sure your hands and feet are dry,and place one hand behind your back to prevent electricity from making a complete circuit through your chest. Touch the plug fuse only by its insulated rim.Remove cartridge fuses with a fuse puller.
- Use tools with insulated handles and ladders made of wood or fiberglass.
- To protect children,place a safely cover over any unused outlets.
DANGER:Before staring installation of this fixture or removal of a previous fixture,disconnect the power by turning off the circuit breaker,removing the fuse at the fuse box,or tripping the breaker that controls that circuit.Tape a sign to the panel warning others to leave the circuit alone while you work.
CAUTION: CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. lf you have any non-electrical questions about this fixture please contact our customer service via the distributor where you purchased this product from. We will be more than happy to assist.
Pre-lnstallation
PLANNING INSTALLATION
Read all instructions before installing.
To avoid damaging this product, place it on a soft, non-abrasive surface, such
as carpet or cardboard.
TOOLS REQUIRED (NOT INCLUDED)
Warranty
ONE (1) YEAR WARRANTY
WHAT IS COVERED
- The manufacturer warrants this fixture to be free from defects in materials and workmanship for a period of one (1) year from date of purchase.
- The warranty applies only to the original consumer purchaser and only to products used in normal use and service.
- If this product is found to be defective,the manufacturer’s only obligation,and your exclusive remedy,is the repair or replacement of the product at the manufacturer’s discretion,provided that the product has not been damaged through misuse,abuse,accident,modifications,alteration,way not in accordance with the instructions supplied with the product.This warranty shall not apply to a failure of the product as a result of an accident,misuse,abuse,negligence, alteration,faulty installation,or any other failure not relating to faulty material or workmanship.
- This warranty shall not apply to the finish on any portion of the product,such as surface and/or weathering,as this is considered normal wear and tear.
WHAT IS NOT COVERED
The manufacturer does not warrant and specifically disclaims any warranty,
whether expressed or implied, of fitness for a particular purpose, other than
the warranty contained herein. The manufacturer specifically disclaims any
liability and shall not be liable for any consequential or incidental loss or
damage, including but not limited to any labor/expense costs involved in the
replacement or repair of said product.
ASSEMBLY GUIDE
Assembly lnstructions
Assembly of this fixture will be accomplished by first determining the length
of stem or chain required, attaching the mounting plate to the junction box,
making all necessary electrical connections, hanging the fixture from the
ceiling and then installing the fixture.
Safety Warning
Read wiring and grounding instruction and any additional directions. Turn
power supply off during installation. If new wiring is required, consult a
qualified electrician or local authorities for code requirements.
HARDWARE INCLUDED
INSTALLATION
Thank you for choosing ACROMA
Documents / Resources
|
ACROMA 3 x Max 60W Candelabra
Base
[pdf] Instruction Manual
3 x Max 60W Candelabra Base, 3 x Max Candelabra Base, 60W Candelabra Base,
Candelabra Base, Base
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>