MYCOND BERG 25 Air Dehumidifier User Manual

MYCOND BERG 25 Air Dehumidifier User Manual

PLEASE KEEP THIS MANUAL FOR FURTHER REFERENCE!
Thank you for selecting our super quality dehumidifier. Please be sure to read this manual carefully before using it. If you have any questions, please contact the professional service for help. Keep the manual for further reference.

The dehumidifier will remove excess moisture from the air, creating a comfortable environment for your home and office. Its compact design allows you to easily move it to any room.

PRECAUTIONS

Read the following notices carefully before operating this dehumidifier. The warnings and notices must be observed effectively to ensure the safety of the operation.

1. Please read the manual carefully before the first time using this product, and storage the unit in safe place to avoid electricity leakage, flaming or person injure.
2. Do not put this product in the water or any other liquids.
3. Stop using this appliance in below situations, or the product might be damaged: power cord and wire is broken, the unit is dropped or break down.
4. Please ask professional service agent to repair the product. Improper repair might cause damage to users.
5. Disconnect the appliance from power supply before moving or cleaning the product, and also when the product is not in used.
6. Please operate the product with specified electricity voltage.
7. Please use this product only for household appliance and follow the designed purpose.
8. Do not put any stuff on the product.
9. In order to avoid water leakage, please clean the water tank before moving the product.
10. Do not incline the product, or leaking water may damage the product.
11. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been supervised or given instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
12. Please keep the product from the wall or other barriers in a minimum distance of 50 cm.
13. Please install the appliance following the country wiring laws.

SPECIFICATIONS

Note: The above technical specifications are subject to change without notice.

APPEARANCE

OPERATION

POWER
Press this key to turn “on” or “off” corres ponding indicating light on or off.

FUNCTION
The function keys have 3 modes: dehumidification, drying, air supply.

1. The power-on defaults to the “dehumidification” function: in the dehumidification function, the device starts to dehumidify.
2. Press the function key once to switch to the “dry clothes” function: in the dry clothes function, the machine enters a continuous working state, the humidity is not adjustable, and the wind speed is high and not adjustable.
3. Press the function key again to switch to the “air supply” function, the compressor stops working, and the fan works normally

AIR PURIFICATION
The air purification button controls the on/off of the air purification function. ( The indicator light is on to indicate that the air purification is in progress.)

HUMIDITY
(Humidity setting) key: Set the required humidity.

1. The humidity settings are: 30%→35%→40%→45%→50%→55%→60%→65%→70%→75%→80% cycle. At the first power-on, the default mode is “30%”.
2. When the indoor humidity is 3% lower than the set humidity, the compressor stops and enters the three-minute protection state, and the fan continues to run for 2 minutes before stopping.
3. When the indoor humidity rises to 3% higher than the set humidity, the fan starts to work, and the compressor (protection state after three minutes) starts to work.
4. According to the above cycle operation, the indoor humidity can be maintained at about the set humidity.

SPEED / LOCK
УThere are three settings: high speed, low speed, and child lock

1. Press the wind speed key to control the fan to switch between high speed and low speed.
2. The first power-on defaults to high wind..
3. When the machine is running, press and hold the wind speed key for 2 seconds, the “LOCK” indicator will be on, and enter the child lock state, and the rest of the keys can not be operated; press and hold the wind speed key for 2 seconds, the “LOCK” indicator will be off, and the child lock state will be released. The keys can be operated normally.

TIMER
Press the key to set the desired time (1-24 hours)

1. Set the time in the standby state to turn on regularly; in the on state, it is to turn off regularly.
2. In the power-on state, press the power button before the set time is reached, the machine will shut down and the set time will be cancelled; in the standby state, when the set time is pressed before the set time is reached, the machine will be turned on and the set time will be cancelled.
3. When there is a timing operation, the timing light is on, and when there is no timing operation, the timing light is off.
4. About five seconds after the timing setting is completed, the dual 8 display will jump back to the display of ambient humidity.

FULL WATER WARNING
When the water tank is full, the full water indicator light will be on, the buzzer will beep 15 times (press any key to contact the alarm), the compressor will stop running, and the fan will stop working after running for 2 minutes; after the water tank is empty, the full water indicator will be indicated the light is off, press the power button to turn on, and the machine resumes normal operation.

WIFI INDICATOR

1. Download the “MYCOND” APP on your mobile phone.
2. Open the “MYCOND” APP and click “Register” to register an account.
3. Turn on the power, press the “Function” button and the “Humidity” button at the same time when the power is off, the WIFI indicator flashes.
4. Click to log in to the APP account, and click “Add Device” on the interface.
5. Click “Auto Discovery”, and when the APP finds the device, click “Next”.
6. Fill in the WIFI user name and password in the pop-up dialog box, and click “OK” to connect.
7. Wait for the machine to connect.
8. If the connection is successful, click “Finish” to enter the operation interface.
   

Note. Before using a mobile phone to connect to the WIFI of the machine, the mobile phone must be connected to WIFI first.

DEFROST INDICATOR
When the defrost indicator light is on, it means that the defrost action has started, the compressor stops running, and the fan continues to run; after 10 minutes of defrost, the defrost indicator light is off, the defrost action ends, and the compressor restarts.
POWER OFF MEMORY FUNCTION
When the machine is running, cut off the power supply and then turn it on again, and the machine will automatically run according to the function set last time.

PROTECTIVE FUNCTION

1. Full water protection
   A water level switch is used to realize the water level protection, the water level switch is normally open, and the full water action is closed. When the water is full, the full water indicator will light up and beep.

2. Compressor protection
   The compressor starts every time you turn it on; when the compressor stops, there is a 3-minute interval protection for restarting.

WARNING

1. When operating the dehumidifier, please do not set the humidity higher than ambient humidity.
2. When indicating light illuminates, please pour the water out of the tank and put it back. Then the product will resume working.
3. When the product shut down, please wait at least 3 minutes before restarting the unit to prevent damaging the compressor.
4. The applicable operating temperature range for this unit is 5-32 °C.
5. If the dehumidifier can’t start (the indicating light does not illuminate) or the dehumidifier shut down unreasonably, please make sure whether the plug is connected firmly to power supply. If the plug and power supply are in normal condition, please wait for 10 minutes before restart the unit (because it takes 10 minutes to reposition). If the unit still does not start after 10 minutes, please ask your local distributor service station to repair.
6. When the dehumidifier is operating, it’s a normal situation that the working compressor may cause some heat and bring the ambient temperature up.
7. When the product is defrosting, the related indicating light will illuminate.
8. The unit shows the ambient humidity when it’s operating. If the ambient humidity is higher than RH80%, the display shows “HI”; if the ambient humidity is lower than RH30%, the display shows “LO”.

DRAINAGE INSTRUCTIONS
This machine has two drainage methods: manual drainage and continuous drainage

1. Manual drainage
   The dehumidified and condensed water flows into the water tank through the drain; when the water tank is full, the full water indicator light will be on, a buzzer will sound, and the equipment will stop working; as shown in figure, take out the water tank and drain the water tank. Empty, then reinstall the water tank, and then press the power button, the machine restarts.

2. Automatic drainage
   Before continuous draining water, please take out the water tank and plug a draining tube to draining hole (See figure) Then put the water tank back. Draining tube should place lower than the draining hole to let water flow out.

MAINTENANCE

WARNING
Please turn off the power and pull out the power plug before maintenance and maintenance of the body.

Surface cleaning
Clean the surface of the machine with a damp soft cloth. Do not use chemical solvents such as alcohol or gasoline, otherwise the surface of the machine will be damaged.

Filter cleaning
Wash twice a week: Take out the filter, wash it in clean water (below 40 degrees) that has been added with neutral detergent, clean it and place it in a cool place to dry (Note: Do not use a brush to brush the net cloth when washing, So as not to damage the mesh cloth of the filter); After drying, put the filter back into the machine.

1. The unit is not allowed to be placed on surface which is soft or not flat to avoid the unit cause noise, vibration, and water or electricity leakage when operating.
2. Never insert any slim rod or hard stuff into the unit to avoid the damage of the unit.
3. Please disconnect the power cord to the power supply when you turn off the unit or intend to stop using for long time..
4. In order to improve the performance of dehumidifier, please keep the unit in open place away from barriers which may block the air.
5. Please wash the filter with cool water (cooler than 40 °C) every two weeks, and put filter back after it air-dried naturally.
   Note. Never use gasoline or alcohol to wash the filter.

DECOMMISSIONING

STORAGE
Long-term storage: If you will not be using the unit for an extended period of time (more than a few weeks) it is best to clean the unit and dry it out completely. Please store the unit per the following steps:

1. Press power button to switch off and unplug the unit.
2. Drain the remaining water from the unit.
3. Clean the filter and let the filter dry completely in a shaded area.
4. Collect the power cord at the water tank.
5. Re-install the filter at its position.
6. The unit must be kept in upright position when in storage.
7. Preserving the machine in ventilating, dry, non- corrosive gas and safe place indoor.

CAUTIONS:

• Switch off the unit and unplug it immediately if you notice something abnormal in the operation of the device.
• Then contact a qualified electrician.
• Do not dispose of electrical appliances as unsorted municipal waste, use special collection facilities.
• Contact your local authorities for information on available collection facilities.
• R134a is a kind of fluorinated greenhouse gases covered by the Kyoto Protocol. Its total global warming potential (GWP) is 1300.
  

Symbols

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>