KARCHER BP 5 Home and Garden Pump Instruction Manual
- June 11, 2024
- Karcher
Table of Contents
KARCHER BP 5 Home and Garden Pump Instruction Manual
Prerequisites for operation
- Only use the pump to pump permissible fluids.
- Use an additional prefilter for dirty (sandy) water.
- Do not connect the pumps in series.
- Do not connect the pump directly to the tap.
- Do not use bayonet connection systems (GK couplings).
- Do not fit a check valve on the suction side directly upstream of the pump. The distance between the pump and a check valve should be at least 3 m.
Checklist
Installation| |
---|---|---
è If the pump is delivered with a pressure tank, connect it to the pump
according to the enclosed instructions.è Ensure that the pressure in the
pressure tank is 3.5 bar.è If the pump is already connected to a water supply,
open all tapping points to ensure that the system is depressurised.|
|
è Connect the pump according the operating instructions.è Ensure that all
screw connections are air-tight.| | **
è Fill the pump with water using the filling nozzle until it overflows.è
Ensure the correct seating of the prefilter (see section “Maintenance and
Care”).| 
| **
è Tighten the lid by hand until it is air-tight.|
| **
è Check all connections for leaks.| 
| **
è Vent pump:1 Open and close all tapping points in the water system once
to ensure that there is no more air in the pipes.2 Completely open the
existing stop valves, and/or ensure that there is sufficient water in the
suction container.3 Switch the pump on in continuous operation (switch
setting “I/On”).4 Allow the pump to run for several minutes until it
pumps uniformly and there is no more air in the system.The pump is now ready
for operation.| 
|
If there are faults on the suction side (LED for faults on the suction side
lights up):è Remove the check valve from the suction hose.A check valve
integrated in the pump offers sufficient protection.è Carefully go through the
installation steps again.| |
If there are faults on the pressure side (fault on the pressure side lights
up):è Carefully go through the installation steps again.| |
Maintenance and care
| |
---|---|---
è Unscrew the lid from the filling nozzle.è Remove the entire prefilter.è
Separate the check valve from the prefilter.|
| **
è Carefully clean the prefilter and the check valve under flowing water.è If
necessary, rinse the residual dirt from the pump.|
| **
è Check the check valve for ease of movement.è If sluggish, lightly grease the
check valve seals using grease (6.288-143.0) avail- able from Kärcher
Service.Do not use mineral lubricants or oils.|
| **
è Connect the prefilter and check filter to each other again.|
| **
è Reinstall the prefilter in the pump.Note the correct installation
position!Position the nose of the prefilter at the matching recess on the
filling nozzle. The prefilter can be inserted without excessive force.|
|
è Start the pump again according to the “Instructions” section.| |
Documents / Resources
|
KARCHER BP 5 Home and Garden
Pump
[pdf] Instruction Manual
BP 5 Home and Garden Pump, BP 5, Home and Garden Pump, Garden Pump, Pump
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>