PROGRESS LIGHTING P550112-031-30 ard-Nox 1-Light Black Polycarbonate Shade Commercial Grade Outdoor Wall or Ceiling Mounted Fixture Instruction Manual
- June 4, 2024
- PROGRESS LIGHTING
Table of Contents
PROGRESS LIGHTING P550112-031-30 ard-Nox 1-Light Black Polycarbonate
Shade Commercial Grade Outdoor Wall or Ceiling Mounted Fixture Instruction Manual
IMPORTANT READ FIRST INSTALLATION INSTRUCTIONS
READ IMPORTANT SAFETY TIPS BEFORE PROCEEDING WITH INSTALLATION
CONSULT A QUALIFIED ELECTRICIAN TO ENSURE CORRECT BRANCH CIRCUIT
SAFETY TIPS
Turn fixture off! (Place wall switch in off position, if fixture has built-in switch or chain pull, switch or pull chain so fixture is off.)
Next – go to the main fuse box. If your fuse box has an ON/OFF switch, simply place main power switch in OFF position.
Screw-in type fuses – unscrew the fuse or fuses that control the power to the fixture or room you are working in.
Remove diffuser (C) from canopy by rotating counter clockwise.
This fixture is designed be mounted to either a wall or ceiling U/L recognized
junction box.
Thread mounting screws (A) into outlet box. Be sure to leave enough of the
screw extended to allow the attachment of the canopy (B).
A. Take black fixture wire(s) and place evenly against the black wire from the
outlet box. Do Not twist wires together before using wire connectors. Fit a
wire connector over the wires
and thread the connector clockwise until you feel a firm resistance. B. Take
white fixture wire(s) and place evenly against the white wire from the outlet
box.
Do Not twist wires together before using wire connectors. Fit a wire connector
over the wires and thread the connector clockwise until you feel a firm
resistance.
C. Take green fixture wire and place evenly against the ground wire from the
outlet box. Do Not twist wires together before using wire connectors.
Fit a wire connector over the wires and thread the connector clockwise until
you feel a firm resistance.
IMPORTANT: OUTLET BOX MUST BE SEALED TO THE WALL. AFTER MOUNTING THE FIXTURE, CAULK MUST BE APPLIED AROUND THE GASKET TO ENSURE NO VOIDS BETWEEN THE SURFACE AND THE FIXTURE. FAILURE TO COMPLY MAY VOID THE WARRANTY.
Align keyholes (E) to mounting screws (A) and push canopy up, rotate clockwise
and tighten mounting screws to secure canopy to mounting surface. Install
diffuser ( ) to canopy (B) by aligning notches
in diffuser flange to tabs on the inside of the canopy. Rotate clockwise unitl
tight.
TO ENSURE WATER AND INSECT RESISTANT SEAL, ALL ENTRY POINTS MUST BE CAULKED.
CLEAN ONLY WITH MILD SOAP AND WATER. AVOID SPRAYING WITH CLEANSERS,
INSECTICIDES, AND PESTICIDES THAT ARE PETROLEUM BASED HYDROCARBON
PRODUCTS. THESE WILL DEGRADE LUMINAIRE.
CAUTION: Do not turn on without diffuser installed. Do not touch LEDs or circuit board. LED optics could be damaged. No lamp replacement required! Integral LED light engine supplied. Do not remove protective cover from LED light engine
Read More About This Manual & Download PDF:
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>