ELYONA UF7016 Wooden Floor Lamp Instruction Manual
- June 4, 2024
- ELYONA
Table of Contents
ELYONA UF7016 Wooden Floor Lamp
Please read the operating instructions before using this device for the first time and store the operating instructions for reference.
STRUCTURE
PACKING LIST
INSTALLATION INSTRUCTION
LED Touch Control
- Smart Ring
- Light ON/OFF
-Tap the ring - Adjust Color Temperature
-Double tap the ring - Adjust Brightness
-Long press the ring
Long Distance Remote Control
IMPORTANT SAFETY INSTRUCTIONS
This unit is suitable for installation in a dry, indoor location only.
Recommended for domestic use ONLY.
Protect the device from humidity,moisture,and high temperatures (including
direct sunlight).
Before starting the installation, shut off the power supply at the electrical
panel by switching off the circuit breaker or removing the appropriate fuse.
Cuting the power at the light switch is not sufficient to prevent electrical
shock.
·DO NOT touch the light bulb with your bare hand, as the oils from your skin
can shorten bulb life. Please handle with a clean cloth.
·DO NOT attempt to modify or repair the lamp yourself.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference
that may cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequence energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation.if this equipmemt does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.