BG ELECTRICAL 907-01 In Line Switches Instruction Manual
- June 11, 2024
- BG Electrical
Table of Contents
ELECTRICAL 907-01 In Line Switches
Instruction Manual
IN-LINE SWITCHES
TECHNICAL HELPLINE: 03300 249 279
SAFETY WARNING
For your safety, this product must be installed in accordance with local Building Regulations. If in any doubt, or where required by the law, consult a competent person who is registered with an electrical self-certification scheme. Further information is available online or from your Local Authority. Please read carefully and use in accordance with these safety wiring instructions. Before commencing any electrical work ensure the supply is switched off at the mains. Either by switching off the consumer unit or by removing the appropriate fuse. Wiring should be in accordance with the latest edition of the IET regulations (BS 7671) To prevent fire hazard always use cable of the correct rating, size & type for the application. Any bare earth wires must be covered with appropriate green/yellow sleeving. Warning do not exceed the load rating of this device as stated on the rear of the product. If in doubt consult a competent electrician.
Assembly Instruction
- Disassemble the unit by undoing the four fixing screws and remove the switch cover.
- Select the position of the switch in the cable, and cut accordingly to the dimensions in Feigl .
- Insert the two conductors into the first set of terminals, ensuring no bare wires are visible. Always tighten the terminal screws tightly. Terminal are marked L + N for your convenience – To assist with the correct installation see Fig2. Repeat for second set of terminals.
- Align cables so they are positioned between the base screw locations, ensuring the outer sheath is located on the ribbed area.
- Repace cover and tighten the four fixing screws. Upon full assembly the screws should be below the surface of the base.
Figure 1. – Cut Cable Lengths
Figure 2. – Wiring Guide
BATCH
CODE EXPLANATION
yywxx : Manufacturing date code; year of manufacturing (yy) week of
manufacturing (Wxx)
Supplied by Luceco PLC
Stafford Park 1
Telford TF3 3BD
ENGLAND
(EU) Luceco SE
C/ Bobinadora 1-5 08302 Mataró SPAIN
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>