FIAMMA 02096-43 Carry Bike Lift 77 Instruction Manual
- June 11, 2024
- FIAMMA
Table of Contents
02096-43 Carry Bike Lift 77
Instruction Manual Bicycles carrier
Installation and usage instructions
02096-43 Carry Bike Lift 77
Please consult the website for instructions in the languages: NL-SV-DA-NO-FI-
PThttps://www.fiamma.it/index.php?route=product/istruzioni&code=WLCZlWbW7t
CARRY-BIKE LIFT 77 02096-43- MOTORHOME
Package contents
Check
that nothing has been damaged or deformed during transport.
In the event of doubts or questions concerning the installation, use or
limitations of the product, contact the dealer. We recommend that the
installation is carried out by qualified personnel and in compliance with
current local regulations.
Installation instructions
Before installing the product, check the strongest points of vehicles’s wall,
where you can fix the brackets.
WARNING!
Do not fully tighten the fork to the tube, leave 2mm space.
Instructions for use
Before leaving, hook always the two security straps.
alphanumeric code
** In case of problems please contact your local dealer indicating the data
on the nameplate. Consult our website for spare parts drawing.
Attention:** keep the following labels and affi them to the Carry-Bike rails.
Safety instructions
Read the
following instructions and warnings carefully; failure to observe these
installation and usage instructions as well as the laws for driving in the
relevant country may cause severe harm or damage for which the manufacturer
declines all responsibility. Before installation, ensure compatibility with
the vehicle on which the product must be installed. In the event of an
accident involving the vehicle and/or the product, ensure that the product has
not been damaged. In the event of damage, contact your local retailer before
moving the vehicle.
Fiamma declines every responsibility for any modifi cation of the product that
may cause damage and/or injury to things and people.
Checking that the wall/rear door is suffi ciently solid and suitable for
guaranteeing the resistance of the anchoring points is always mandatory. If
not, strength and compliance with the maximum load indicated in the
instructions are not guaranteed and it will be necessary to reinforce these
points.
After having positioned the Carry-Bike on the rear axle of the vehicle, the
normal weight distribution on both axles would be modifi ed. This variation
must not exceed the maximum permissible axle load.
Never exceed the maximum permitted length and the total weight of the full-
load vehicle.
Make sure that loading occurs following a correct weight distribution; it must
be uniformly distributed (the heaviest bike must be placed near the wall of
the vehicle) to ensure better stability.
Always give warnings about the presence of the Carry-Bike on your vehicle,
using a clearly signal for leaning loads and, in case of limited rear
visibiliy, use the additional rear-view mirrors.
Take into account the presence of the Carry-Bike, paying attention during
driving and expecially during reversing manoeuvres, particularly if you have
parking assist system. Always comply with speed limits and the Highway Code.
The speed should always be suitable to traffi c conditions and towed load. In
case of use of the bike carrier with tow make sure that the tow hook is always
accessible and the corner mobility of the tow is guaranteed (volume measuring
din 74058).
Check periodically the bicycle rack to make sure it is fi rmly attached,
especially during the fi rst kilometers of after long trips to avoid damages of
the Carry-Bike/vehicle. Make sure the belts are not loose and that the holding
brackets have not shifted. Replace worn components immediately.
It is advisable to remove the batteries from bicycles, before loading them on
the Carry-Bike while traveling. It is recommended to rotate the handlebars of
bicycles to avoid damage to the vehicle wall, for which Fiamma declines all
responsibility.
Accessories
Warranty
fiamma.com
Fiamma S.p.A. – Italy
Via San Rocco, 56
21010 Cardano al Campo (VA)
All rights reserved.
Fiamma S.p.A.
reserves the right to modify at any time, without notice, prices, materials,
specifi cations and models or to cease production of any model.