Centek CT-1330 Hand Blender Instruction Manual

Centek CT-1330 Hand Blender

DEAR CUSTOMER!
Prior to operating the appliance, please carefully read the present manual which contains important information regarding its proper and safe operation. Take care not to lose the present manual. The manufacturer will not be responsible for any damage resulting from improper use of the appliance or from non-observance of the instructions and provisions of the present manual, as well as from attempts by unskilled persons at repairing the appliance. Should You decide to transfer the appliance to another person, please pass the present manual over along with it.
PURPOSE OF THE APPLIANCE For the quick chopping and mixing of foods. The blender set is a home appliance and is not designed for industrial applications!

SAFETY PRECAUTIONS

The following requirements should be strictly observed in order to avoid situations hazardous for human life and health, as well as premature failures of the appliance:

• Carefully read the present manual prior to operating the appliance.

• Retain the present manual, cash voucher and appliance packaging. If lost, the manual cannot be renewed and the warranty on the appliance becomes void. Use the appliance only for its intended purpose.

• Do not place the appliance near heat sources, do not expose it to direct sunlight and moisture (do not submerge in water and other liquids). Do not touch the appliance with wet hands.

• In case of ingress of moisture or leakage from the appliance, immediately disconnect it from the power supply.

• Do not install the appliance on soft, uneven, unstable surfaces. Do not cover the appliance.

• Always disconnect the appliance from power supply after use and before cleaning. When disconnecting the appliance from the power socket grab and pull the plug, not the cable.

• If the power cable is damaged, in order to avoid dangerous situations, have it replaced by the Manufacturer, a maintenance service or similar skilled personnel.

• Do not leave the appliance unattended. Ensure that the power cord is routed out of reach of children.

• The appliance should not be used by physically, sensory or mentally handicapped persons (including children) or by persons without sufficient experience or knowledge, unless such persons are under supervision, or have been instructed on the use of the appliance, by the persons responsible for their safety. Take precautions not to let children play with the appliance.

• Regularly check the appliance and its power cable for damage. Operating a damaged appliance is not allowed.
  Do not attempt to repair the appliance yourselves, apply to certified technicians. – Only the use of original spare parts is allowed. Do not use accessories which are not included in the scope of supply.

• Ensure that the power supply grid voltage corresponds to the one indicated on the appliance before operating it.

• Before turning the appliance on ensure that it is fully and correctly assembled. Do not pull the power cable if it touches sharp edges, is jammed by any objects or entangled; avoid contact of the power cable with hot surfaces.

• In case of unskilled intervention into the appliance or non-observance of the operating requirements listed in the present manual the warranty becomes void.

• Connect the appliance only to power grid sockets equipped with earthing contacts, use only two-pole extension cables with 10A rating and an earthing conductor.

• Do not use multiple high-power appliances simultaneously ­ this may lead to malfunctions in residential power supply systems.

• The appliance should only be disassembled after the motor has come to a complete stop.

• Do not use the appliance if:
  · the power cord is damaged; · the appliance has visible damage; · the appliance has been dropped from height; · the appliance has been exposed to moisture.

• Ensure the appliance is turned off when not in use!

• Do not operate the appliance at temperatures below 0 ° and above 35 °. If the appliance has been exposed to temperatures below 0 ° for a prolonged time, place it in a heated environment for at least 3 hours before turning it on. – Pull the plug from the power socket if: the appliance does not work correctly (unusual noise, vibration, etc.); before disassembly/reassembly; after each use. Disconnect the appliance from power supply if You have to leave it unattended for even a short time.

• Packaging materials can be potentially dangerous to children and should be stored in a specially designated location.

• Special instructions for transportation (shipment) and sale: none.
  ATTENTION! Electric shock hazard! Never submerge the appliance in water! ATTENTION! Fire hazard! Avoid all contact of the appliance with flammable liquids and combustible materials!

APPLIANCE DESCRIPTION

1. Smooth power control
2. The main mode power button
3. TURBO mode button
4. Motor unit
5. Blender attachment
6. Connecting block
7. Whisk attachment
8. Chopper cover
9. Chopper blade
10. Chopper bowl
11. Measuring cup

SCOPE OF SUPPLY AND CONTROLS

• Blender body – 1 pc.
• Blender attachment – 1 pc.
• Measuring cup – 1 pc.
• Whisk – 1 pc.
• Chopper – 1 pc.
• User Manual – 1 pc

OPERATING PROCEDURE

PREPARATION

Before connecting the appliance to power supply ensure that the power grid voltage correspond to that indicated on the appliance. Remove all packaging materials. Clean the attachment (see MAINTENANCE Section).

HAND-HELD BLENDER

The blender is designed for mixing liquids (e.g. mixing diary foods, sauces, fruit juices, soups, drinks and cocktails) and soft ingredients (e.g. purees, baby food ingredients, etc.).

1. Install the blender attachment and connect the appliance to power supply.
2. Fully submerge the cutting disc guard into the glass.
3. Press the main mode button or the TURBO button to turn the appliance on.
4. Slowly move the appliance up and down and in circles to uniformly blend all ingredients.

CHOPPER

The chopper is designed for chopping meat, cheese, onions, herbs, garlic, carrots, walnuts, hazel nuts, almonds, etc. Use the TURBO button to chop hard foods. Do not try to chop overly hard materials such as nutmeg, coffee beans or cereals. Before using the chopper: – Cut the food into small pieces;

• Cut the food into small pieces;

• Remove stalks from herbs and the shells from nuts;

• Remove bones, sinews and gristle from meat.

1. Install the blade in the chopper bowl center mount and fix it in place.
2. Place the ingredients (max. 250 g) in the bowl.
3. Install the chopper lid.
4. Insert the blender housing into the coupling and ensure that it is properly engaged.
5. Press the TURBO mode button to activate the unit.
6. After use, press the attachment release button to disconnect the blender unit from the chopper bowl.
7. Turn the lid counterclockwise to disconnect it and lift it up.
8. Remove the blade by gently turning and lifting it.

USING THE WHISK ATTACHMENT

Use the whisk attachment only for whipping cream, making sponge dough or mixing ready-made desserts.

1. Insert the whisk attachment into the device body.
2. Connect the appliance to the mains.
3. Put the ingredients in a bowl (for best results, use a large and deep bowl).
4. Immerse the whisk completely in the whipped product. To avoid splashing, start the whipping at a slow speed.
   ATTENTION! Before assembling, make sure that the plug of the power cord is not plugged into an outlet.
   ATTENTION! It is forbidden to use a whisk for kneading a steep (tightly kneaded) dough. The products are placed in the container before the device is turned on. Do not overfill the mixing container.

MAINTENANCE

ATTENTION!

• Carefully remove all attachments.
• Use a slightly damp cloth to wipe the motor and gear units of the blender, then wipe them dry. – After processing salty and sour foods immediately rinse the used attachments with water.
• When processing highly staining foods (e.g. carrots or beets) the attachments and vessels may become stained; wipe them with fabric dampened in vegetable oil, then rinse with water.
• Wash the attachments, measuring cup, bowl with warm water, rinse and let dry.
• Place the shredding blade into the bowl, put the plastic cap on the blade. Never submerge the motor and gear units in water or any other liquids, wash them under a jet of water or place in a dishwasher. Clean the appliance before putting it away for prolonged storage.
• Do not wind the power cord around the motor unit. – Store the blender set in a cool dry place, out of reach of children.

SPECIFICATIONS

• Rated voltage: 220-240 V ~50/60 Hz
• Nominal power rating : 1000 W
• Maximum power rating : 1500 W

DI SPOSAL

Upon expiry of its service life the appliance can be disposed of separately from ordinary domestic waste. You can turn it over to a specialized electric and el ecteronic appliance disposal and recycling centre.

CERTI FI CATI ON DATA, GU ARANTEE

The service life of this item is 5 years since the date of sale to the end user, provided the item will be used in strict accordance with the present manual and the applicabl e technical standards. Upon expiry of the service life pl ease contact the nearest authorized service centre for suggestions as to further operation of the appliance. The manufacturing date of the appliance is integrated into the serial number (digits 2 and 3 – year, digits 4 and 5 – month of manufacture). If any questions rel ated to appl iance maintenance shoul d arise, or if the appl iance has mal functions, appl y to the CENTEK TM Authorized Service Center. The address of the service center can be found on the website https://centek.ru/servis. Service support contacts: Phone: +7 (988) 24-00-178, VK: vk.com/centek_krd. General Service Center: OOO «Larina- Servis», Krasnodar, Phone: +7 (861) 991-05-42. The product is provided with the Certificate of Conformity: RU -CN.07..02975/21 of 08.02.2021 y.

MANU FACTU RER AND I MPORTER I NFORMATI ON

I mport ed t o EAEU by: Individual niy Predprinimatel Asrumyan Karo Shurikovich. Addr ess: Russia, 350912 Krasnodar, ul . Atamana Lysenko, 23, pgt. Pashkovskiy, phone: +7 (861) 2 600 900.

DEAR VALUED CONSUMER!

The guarantee period for all appliances amounts to 12 months since the date of sale to the end consumer. With this Warranty Card the Manufacturer confirms the proper condition of the appliance and undertakes to repair, free of charge, all defects caused by the Manufacturer’s default.

GUARANTEE MAINTENANCE TERMS

1. The guarantee shall be valid if the following documentation conditions are observed: – The original Warranty Card shall be filled out correctly and clearly, indicating the of appliance model, serial number and sale date, the stamp of the seller company and signature of its representative shall be available, as well as the stamps on each coupon and the buyer’s signature in the Warranty Card. The Manufacturer reserves the right to reject guarantee maintenance if the buyer fails to provide the abovementioned documents or if the information contained therein is incomplete, illegible or ambiguous.

2. The guarantee shall be valid if the following operation conditions are observed: – the appliance is used in strict accordance with the present manual; – the safety rules and requirements are observed.

3. The guarantee does not apply to regular maintenance, cleaning, installation and setup of the appliance at the owner’s location.

4. The guarantee does not apply in the following cases:
   ● mechanical damage;
   ● normal wear of the appliance;
   ● non-observance of operation requirements or erroneous actions on the part of the user;
   ● improper installation or transportation;
   ● natural disasters (lightning, fire, flood, etc.), as well as any other causes beyond the Manufacturer’s or Seller’s control; – ingress of foreign objects, liquids or insects into the inside of the appliance;
   ● repairs or modifications to the appliance by unauthorized persons;
   ● use of the appliance for commercial purposes (loads exceeding normal domestic application), connection of the appliance to utility and telecommunication networks incompliant with national technical standards;
   ● failure of the following accessories, if replacement of these is allowed by design and does not involve disassembly of the appliance:
   a) remote control units, rechargeable batteries, replaceable batteries (power cells), external power supply units and chargers;
   b) consumables and accessories (packaging, covers, slings, carry bags, mesh screens, blades, flasks, plates, supports, grilles, spits, hoses, tubes, brushes, nozzles, dust collectors, filters, smell absorbers);
   ● for battery-powered appliances ­ operation with inappropriate or depleted batteries;
   ● for rechargeable battery-powered appliances ­ any damage caused by improper battery charging and recharging.

5. The present guarantee is provided by the Manufacturer in addition to the consumer rights determined by the applicable legislation and does not limit these rights in any way.

6. The Manufacturer shall not be made liable for possible damage, directly or indirectly inflicted by CENTEK brand products on people, domestic animals, the consumer’s or third persons’ property if such damage is inflicted as the result of non-observance of appliance installation and operation requirements, deliberate or negligent actions (omission) by the consumer or third persons, as well as of force majeure circumstances.

7. Service centers will only accept appliances in a clean state (there should be no food residues, dust and other contamination on the appliance).
   The Manufacturer reserves the right to change the design and specifications of the appliance without prior notice.

References

• VK.com | VK
• Сервис - Официальный сайт Centek

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>