anywAiR Setting Up Scenes User Guide
- June 7, 2024
- anywAiR
Table of Contents
anywAiR Setting Up Scenes
Setting Up Scenes
The anywAiR® technology Wi-Fi adaptor allows you to set up Scenes within the myanywAiR app. A Scene allows you to set up different scenarios that can activate all at once either at the touch of a button, or voice command (if smart devices are connected). For example, you can set up a Scene called ‘Living Room On’ that will turn your living room air conditioner on at 5pm every day when arriving home, setting it to 22 degrees, cooling mode, with auto fan speed and swinging vanes. In this guide we will show you how to set up Scenes on your myanywAiR app.
IMPORTANT
If you wish to control a scene using voice commands, you must first have your
desired scenes already setup through the myanywAiR app prior to linking your
account with other smart devices.
How To Set Up Scenes
To begin, open up the myanywAiR app on your smartphone.
STEP 1
From the main screen select ‘Scenes’.
STEP 2
On the Scenes page select the ‘+’ in the top right hand corner.
STEP 3
This will open up the New Scene page. Enter the name for the scene you want to
set up.
STEP 4
For example ‘Living Room On’. Then select the device name you want to set this
scene for.
STEP 5
All the available settings will appear grayed out. You must select which ones
you want to run for each scene.
STEP 6
For this example we want the ‘Living Room On’ scene to turn the unit on, set
it to 24 degrees, cooling mode, fan speed high, left/right and up/down vanes
on swing.
STEP 7
Once all your options are set you can exit back to the previous screen by
selecting the scene name in the top left hand corner.
STEP 8
You can either save it as is without a timer or set a timer from this screen.
To finish here select ‘Save’ in the top right hand corner.
STEP 9
Select Temporized on to enable the timer function. Select your preferred time
and whether you want it to repeat every day.
STEP 9
Once done you can select ‘Save’ in the top right hand corner to finish.
STEP 10
Your preconfigured scene will now appear in your Scenes page where you are
able to switch it on or off by selecting it.
STEP 11
To run your preconfigured scene, simply select it and you will be notified of
it running in the top bar.
To edit a Scene simply follow the steps below.
STEP 1
From the Scenes screen, select ‘Edit’ in the top left hand corner.
STEP 2
In the Edit screen select the scene which you want to edit or remove the scene
by selecting the red dash next to the scene name.
STEP 3
Here you can edit the name of the scene, the temporized/timer, repeat
function, or the device it’s operating on.
STEP 4
By selecting the device again you’re able to edit the set functions within
that screen. Repeat previous Steps 7 to 10 to finish editing.
STEP 5
If you have more than one device you are able to use the configured scene on
each device by selecting each device name and adjusting the settings as
required.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>