BRAUN 575 PocketGo Portable Battery Shaver Instruction Manual
- June 13, 2024
- Braun
Table of Contents
BRAUN 575 PocketGo Portable Battery Shaver
Product Description
Instruction For Use
Batteries
Two 1.5 volt batteries.
For best performance, use alkaline manganese batteries (type LR 6, AM 3, MN
1500 or size AA alkaline, e. g. Duracell®). These batteries provide a shaving
capacity of approx. 60 minutes.
To open the battery cover (6), turn it 90° as shown in (c). Insert batteries
with the poles in the direction marked. Before closing the battery
compartment, make sure the cover is dry and clean.
Note: Never leave batteries in the shaver for long periods of time when the shaver is not in use (danger of leakage). Take empty batteries out of the shaver immediately. To protect the environment, dispose of empty batteries at your retail store or at appropriate collection sites according to national or local regulations.
This appliance is suitable for use in a bath or shower. When using it in a shower, we recommend that you apply shaving foam or gel.
Shaving
Turn the twisting protective cap (4) (a) until it clicks in place as shown (b). To switch the shaver on, push the on/off switch (3) up.
Long hair trimmer
(575 and 570 models only)
Use the extendable long hair trimmer (5) for exact trimming of sideburns and
moustaches. To operate, slide the long hair trimmer to the right (e) and turn
on the appliance. After use, slide it back until it engages.
Cleaning and maintenance
For optimum shaving performance, clean the shaver after each use:
Cleaning under running water
Turn on the shaver and hold the shaver head under warm running water (f). You may also use liquid soap. Rinse off all foam and let the shaver run for a few more seconds. Then turn it off and remove the shaver foil (1) as shown (g) and let it dry. If you often clean your shaver under running water, put a drop of light machine oil onto the shaver foil.
Cleaning with the brush
Remove the shaver foil (1) and tap it gently against a flat surface. Then thoroughly clean the cutter block (2) with the brush (7) as shown in (i). Do not clean the shaver foil with the brush as this may damage it.
After cleaning, turn the twisting protective cap (4) 180° to cover the shaving head. In this position, the on/off switch is automatically locked to avoid accidental operation of the shaver (e. g. when travelling).
Subject to change without notice.
This product conforms to the EMCDirective 89/336/EEC.
Please do not dispose of the product in the household waste at the end of its useful life. Disposal can take place at a Braun Service Centre or at appropriate collection points provided in your country.
Customer Support
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>