LOGIC X57A 5.7Inch 3G Smartphone User Guide
- June 9, 2024
- Logic
Table of Contents
X57A 5.7Inch 3G Smartphone
User Guide
X57A 5.7Inch 3G Smartphone
Thank you for purchasing this innovative LOGIC device. The specifications in
this document are subject to change without prior notice.
LOGIC and the LOGIC logo are registered trademarks of Swagtek, Inc. Other
trademarks are the property of their respective owners.
**Charge for 24 hours before using.
**
Install SIM card / memory card.
Get
to know your Logic phone
Connect your Logic phone to the computer using the USB cable.
Copy music files from your computer to your Logic phone. 
FCC Statement
-
Ths device complies with Port IS of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause hormfu interference.
(2) This device must accept any interference received, including interference that may couse undesired operation. -
Changes or modifications not expressly approved by the party responsidle for compliance could void the user’s authority to operate the equipment.
NOTE; This equipment has been tested and found to comply with the lrnits
for a Class B digtal device, pursuant to Part IS of the FCC Rules. These
limits are designed to provide reasonable Protection against harmful
interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and. if
not installed ond used in accordance with the instructions, may cause harmful
interference to adio communications. However, there is no guarantee that
interference wil mot occur in a Particular installation If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
– Reonent or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on o orcuit different from that to
which the recewver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and receiver. It is designed and manufactured not to exceed the emission linnits for exposure to radiofrequency {RF} energy set by the Federal Communications Commission of the U.S. Government. These limits ore port of comprehensive guidelines and estoblish permitted levels of RF energy for the general Population The guidelines are based on standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific studies The standards include a substantial sofety margin designed to assure the sofety of all persons, regardless of age and health. The exposure standard for wireless mobile phones employs a unit of measurement known as the Speafic Absorption Rate, or SAR The SAR limit set by the FCC is 16 Wikg. * Tests for SAR are conducted with the phone transmitting at its highest certified power level in all tested frequency bonds. Although the SAR is determined at the highest certified power level, the actual SAR level of the phone while operating can be well belaw the maarnum value, Ths is because the phone is designed to operate at multiple power levels so 05 to use only the power required to reach the network. In general, the closer you ore to a wireless base station antenna. the lower the power output. Before a phone model is available for sale to the public. it must be tested and certified to the FCC that it does not exceed the imit established by the government adopted requirement for safe exposure. The tests ore performed in positions ond locabons (eg. at the ear and wom on the body) os required by the FCC far each model. The highest SAR value for this model phone when tested for use at the ear is 0.396W/Kg and when worn on the body, as described in this user quide, is O472W/Kg{Body-worn measurements offer among phone models. depending upon available accessories ond FCC requirements). The maxirnum scaled SAR in hotspot mode is. O.498W/Kg, While there may be differences between the SAR levels of various phones and at various positions, they all meet the government requirement for safe exposure. The FCC has granted an Equipment Authorization for this model phone with all reported SAR levels evaluated as in compliance with the FOC RFexposure guidelines. SAR information on this model phone is on file with the FCC and can be found under the Display Grant section of http://www.fcc.gov/oet/foad after searching on FCC ID 055573120 Additional information on Specific Absorption Rotes (SAR) can be found on the Cellulor Telecommunications Industry Asso-ciation (CTIA) web-site at http://www.wow-com.com. ° In the United Stotes and Canada, the SAR limit far mobile phones used by the public is 16 watts/kg (W/kg) averaged over one grom of tissue. The stondard incorporates o sub-stantial margin of safety to give additional protection for the public ond to account for any variations in measurements.
Body-weom Operation
This device wos tested for typical body-worn operations. To comply with RF exposure requirements, a minum separation distance of LOmm must be maintained between the user’s body and the hondset. induding the ontenna Third-party belt-clos. holsters, and simikr accessories used by this device shoud not contain ony metolic components. Body-worn accessories that do not meet these requirements may not comply with RF exposure requirements and should be avoided. Use only the supplied or an approved antenna.
Warranty Certificate Terms and Conditions
LOGIC warrants that their Products will be free from defects in material and
workmanship. The warranty period is one (1) year for the products and three
(3) months for the accessories which are part of the original package
including the battery. The warranty period begins the date of purchase by the
End-User who shall present an invoice or a purchase receipt when requiring
warranty service otherwise the warranty period will begin from the date of
manufacture of the product. LOGIC will repair a product without cost to the
customer if it presents a manufacturing defect or defect in workmanship during
the warranty period and if the defect occurred under normal conditions of use
in accordance with the instructions and specifications stated in the user’s
manual.
For additional information about the terms and conditions of LOGIC’s Limited
Warranty or to obtain warranty service information, please visit the support
section at: logicmobility.com
logicmobility.com
Made in China Copyright
Swagtek, Inc. 2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>