FEIT Electric BTBR305CCTECP Electric LED Lamp Instruction Manual
- June 9, 2024
- Feit Electric
Table of Contents
FEIT Electric BTBR305CCTECP Electric LED Lamp
Product Information
The product is a device that complies with part 15 of the FCC Rules. It is designed to operate without causing harmful interference and must accept any interference received, including interference that may cause undesired operation. The device should be installed and operated with a minimum distance of 20cm between the radiator and your body to comply with FCC radiation exposure limits set forth for an uncontrolled environment.
Product Usage Instructions
When using the device, ensure that it is installed and operated with a minimum distance of 20cm between the radiator and your body. Failure to do so may result in exceeding the FCC radiation exposure limits for an uncontrolled environment. Any changes or modifications to the device not expressly approved by the party responsible for compliance could void the user’s authority to operate this device. Therefore, it is recommended that users do not attempt to modify or change the device in any way.
If you experience any interference while using the device, please ensure that it is not caused by any other electronic devices in close proximity. If the interference persists, contact the manufacturer for assistance. Please refer to the user manual for further instructions on how to operate and maintain the device.
Single Bulb Pairing Instructions
- Power on the bulb. The bulb will automatically initiate pairing mode.
- Using a compatible Blue1Doth device, search for “10-sYNC SPEAKER BULB”.
- Walt for the bulb 1D blink twice (that signifies successful pairing). Open your favorite music streaming application and play music.
Multiple Bull Pai1ng instructions
- Power on up 1D 1 O bulbs at the same time. The bulbs will automatically initiate pairing mode.
- Using a compatible Blue1Doth device, search for “10-SYNC SPEAKER BULB”. One bulb will default 1D to the primary bulb.
- Wait for the primary bulb 1D to blink twice (that signifies successful pairing). Then wait for the other bulb(s) 1D automatically connects 1D to the primary bulb.
- Open your favorite music streaming application and play music.
NOTE:
If the primary bulb loses power or Blue1Doth connection, no audio will be
outputted by the secondary bulbs. Power must be restored 1D the primary bulb
or a different bulb must be assigned as primary via the Blue1Doth menu on the
mobile device.
FCC STATEMENT
Caution
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this device.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operations.
Note:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled controlled environment. This device should be installed and
operated with a minimum distance of 20cm between the radiator and your body.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>