CHICOLOGY C8-50-4500 Roller Shades Instruction Manual

CHICOLOGY C8-50-4500 Roller Shades

Installing the Shade

• Please refer to the provided Roller Shades installation instructions — to install the shade prior to setting up the motorization.

Installing the Valance or Fascia

• Please refer to the provided Roller Shades installation instructions — for installing Fabric Cornice and Deluxe Valance or Shades with Fascia.

Adjusting Limits

Adjusting Upper Limit

• Hold UP and STOP on controller tor Response:
• Move shade to the desired height position by pressing the UP or Down button
• To save upper limit, hold UP and STOP Motor Response

Adjusting Upper Limit

• Hold DOWN and STOP on controller Motor Response:
• Move shade to the desired height position by pressing the UP or Down button
• To save lower limit, hold DOWN and STOP Motor Response:

Adding or Removing Controllers and Channels

Using Motor P1 Button

• Hold P1 button on motor head Motor Response:
• Hold STOP on controller to add or remove Motor Response

Adding or Removing Controllers and Channels

Using a Pre-existing Controller

• A = Existing controller or channel (to keep)
• B = Controller or channel to add or remove
• Press P2 on controller A Motor Response:
• Press P2 on controller A Motor Response:
• Press P2 on the controller B to remove it Motor Response:
• IMPORTANT: Consult user manual for your controller or sensor.

Favorite Position

Setting a Favorite Position

• Move shade to the desired height position by pressing the UP or Down button
• Press P2 on controller Motor Response:
• Press STOP on controller Motor Res
• Press STOP on controller Motor Response:

Send Shade to Favorite Position

• Press STOP on the controller

Favorite Position

Deleting Favorite Position

• Press P2 on controller Motor Response:
• Press STOP on controller Motor Response:
• Press STOP on controller Motor Response:

Adjusting Speed

Increase Motor Speed

Default motor mode is the slowest speed.

• Press P2  Motor Response
• Press UP Motor Response:
• Press UP Motor Response

IMPORTANT: If motor does not react to speed adjustment, the maximum or minimum speed has already been reached.

Charging the Motor Battery

The motor has a 5V built-in Li-ion battery pack with integrated charge management

Charge with AC Charger
To charge the battery with the AC Charger, simply plug the charger cable end into the charger wire on the motor. Plug the charger into an electrical outlet and charge for approximately 6 hours. When the light turns green, continue to charge for 1 to 2 more hours to ensure battery is fully charged.

Replacing the Battery in the Remote

• Remove cover from remote press gently in and down to disengage cover.
• Install battery with positive (+) side facing up

CHILD SAFETY

WARNING

STRANGULATION HAZARD – Young chidren can be strangled by cords. Immediately remove this product if a cord longer than 22 cm or a loop exceeding 44 cm around becomes accessible. Rev 7/21 Print 7/21

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>