PLT SOLUTIONS PLT-90181 LED Wraparound Fixture Instruction Manual

June 9, 2024
PLT SOLUTIONS

PLT SOLUTIONS PLT-90181 LED Wraparound Fixture Instruction Manual
PLT SOLUTIONS PLT-90181 LED Wraparound Fixture

SAFETY AND INSTALLATION INSTRUCTION

  WARNING

  • Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
  • To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the fixture box and all fixture labels.
  • Proper grounding is required to ensure safety.
  • Power must be turned off at the breaker before installation or maintenance.
  • Installation, service, and maintenance of luminaires should be performed by a qualified licensed electrician.
  • Wear gloves and eye protection at all times while installing, servicing, or preforming maintenance on the luminaire, and avoid direct eye exposure to the light source while it is on.
  • Do not install damaged product. Inspect luminaire for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
  • These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

WARNING

  • Account for small parts and destroy packing material, as these may be hazardous to children.
  • Risk of burn. Disconnect power and allow fixture to cool before handling.

CAUTION

  • All wiring connections should be capped with UL approved wire connectors.
  • Verify that supply voltage is correct by comparing it with the luminaire label information.
  • The green ground screw is provided in the proper location. Do not relocate.
  • Minimum 90° supply conductors.

NOTICE

  •  Specification and dimension subject to change without notice.

Installation Instruction
Installation Instruction

  1. Remove the fixture from the packaging.
  2. Remove the lens by pulling from one side of the fixture and hinge on the other.
  3. Mark the mounting holes on the ceiling at each end of the fixture housing.
  4. Lay the luminaire aside and drill the holes.
  5. Insert anchors into place and screw luminaire into place.
  6. Make electrical connections according to applicable codes.
  7. Install channel cover.
  8. Install lens on one side of the fixture and gently press to engage the opposite side.

Wiring Diagram

Wiring Diagram

Costumer Support

972-535-09261
pltsolutions.com
ver 013023

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

PLT SOLUTIONS User Manuals

Related Manuals