PLT SOLUTIONS CCT Selectable LED Track Heads Instruction Manual

Table of Contents

WARNING

Before installing, servicing, or performing routine maintenance upon this equipment, follow these general precautions.
To reduce the risk of death, personal injury, or property damage from fire, electric shock, falling parts, cuts/abrasions, and other hazards, read all warnings and instructions included with and on the track head box and all track head labels.
Proper grounding is required to ensure safety.
Power must be turned off at the breaker before installation or maintenance.
Installation, service, and maintenance of track heads should be performed by a qualified licensed electrician.
Wear gloves and eye protection at all times while installing, servicing, or performing maintenance on the track head, and avoid direct eye exposure to the light source while it is on.
Do not install damaged product. Inspect track head for damage that may have occurred during transit. If damaged, contact the manufacturer immediately.
These instructions do not purport to cover all details or variations in equipment nor to provide every possible contingency to meet in connection with installation, operation, or maintenance. Should further information be desired or should particular problems arise which are not covered sufficiently for the purchaser’s or owner’s purposes, contact the manufacturer.

WARNING

To avoid the risk of fire or short, do not use the connectors and end cap without busbar stoppers.

PLT SOLUTIONS CCT Selectable LED Track Heads 01

CAUTION

Before installing the track heads, make sure the copper conductors are in the desired position.
To use the track heads on a one-circuit track, the copper conductor on the top of the track head must be in the lower position. For two-circuit lighting, the copper conductor should be in the lower position for one-circuit and raised for the second circuit. To position the conductor, gently push down or pull up.
Two-circuit track systems are designed for use when two separately controlled circuits are needed on one section of track. Each circuit is rated for 2400 watts and will allow you to control two individual sets of fixtures.
When mounted on a two-circuit track, some track head conductors can be positioned up while others are positioned down to achieve use of both circuits.

PLT SOLUTIONS CCT Selectable LED Track Heads 04

One-Circuit Track

PLT SOLUTIONS CCT Selectable LED Track Heads 05

Two-Circuit Track

Turn power off from the electrical panel before starting installation.
Pull down the conductor cowling and insert the copper conductor into the track.
Rotate 90° and lock into place.
a. NOTE: The polarity line on the track head must align with polarity line on the track.
To remove the track head, pull the conductor cowling down and rotate the track head 90°.

PLT SOLUTIONS CCT Selectable LED Track Heads 06

Select the color temperature by positioning the 3-step switch to the desired setting.

PLT SOLUTIONS CCT Selectable LED Track Heads 07

Adjust the Slider to a minimum of 50% before switching on the light or flickering may occur.

Sometimes flickering can occur if LEDs are operated lower than 10%. To eliminate flickering, adjust the slider above 10%, as shown as Point A in the diagram on page 5, to a range between 10% and 100%.