8BitDo SN30 Pro Bluetooth Gaming Controller Instruction Manual
- June 9, 2024
- 8Bitdo
Table of Contents
SN30 Pro for Android — instruction manual
- white status LED
- power LED
- RB, RT
- menu
- RSB, RTS
- profile LED
- profile
- Xbox
- star
- LSB, LTS
- d-pad
- view
- LB, LT
- pair
-
press Xbox button to turn on the controller.
-
hold Xbox button for 6 seconds to turn off the controller.
-
-
Android
- system required: Android 9 or above
Bluetooth Connection
-
press Xbox button to turn on the controller, status LED starts to blink.
-
hold pair button for 3 seconds to enter its pairing mode, status LED starts to blink rapidly.
(This is required for the very first time only) -
go to your Android device’s Bluetooth setting , pair with [ 8BitDo SN30 Pro for Android ], LED stays solid when connection is successful.
Wired Connection
- OTG support is required on your Android device, please contact your device manufacturer for more details. Connect the controller to the USB port of your Android device, wait till the controller is successfully recognized by your Android device to play.
Apple®
- required system: iOS 16.3, iPadOS` 16.3, tvOS’ 16.3, macOS°13.2 or above.
Apple, iPadOS, macOS, and tvOS are trademarks of Apple Inc., registered in the U.S. and other countries.
Bluetooth Connection
1. press Xbox button to turn on the controller, status LED starts to
blink.
2. hold pair button for 3 seconds to enter its pairing mode, status LED
starts to blink rapidly.
(This is required for the very first time only)
3. go to your Apple device’s Bluetooth setting , pair with [ 8BitDo
SN30 Pro for Android ]. LED stays solid when connection is successful.
Wired Connection
- USB wired connection is only available for macOS or iPadOS devices with USB-C ports. Connect the controller to the USB port of your Apple device, wait till the controller is successfully recognized by your Apple device to play.
Button Swap
- LED blinks continuously when the swapped button is pressed.
- the swapped buttons will not be saved after turn off the controller.
- D-Pad, view, menu, LT, RT and Xbox buttons are not supported.
Hold either two buttons you would like to swap, then press the star button to activate/deactivate the button swap.
Battery
Built-in 480mAh Li-on battery with 16 hours of play time, rechargeable with Ito 2 hours charging time.
status LED indicator
low battery mode → red LED blinks
battery charging → green LED blinks
battery charged → green LED stays solid
- the controller will turn off in 2 minutes with no connection or15 minutes of inactivity when connected with Bluetooth.
- controller stays on with USB connection.
Ultimate Software
-
it gives you elite control over every piece of your controller: customize button mapping, adjust stick & trigger sensitivity. Please visit support.8bitdo.com for the application.
-
press profile button to activate/deactivate the custom profile. The profile indicator will not light up when using the default setting.
-
-
support
- please visit support.8bitdo.com for further information & additional support.