AUDAC SSP500 2-Way Flush Mount Sauna Speaker Installation Guide
- June 9, 2024
- AUDAC
Table of Contents
SSP500 2-Way Flush Mount Sauna Speaker
AUDAC PROFESSIONAL AUDIO EQUIPMENT
The 2-Way Flush mount Sauna Speaker SSP500 is designed to provide high-quality audio in sauna environments. The speaker is designed to be mounted on the wall or ceiling and is equipped with a moisture-resistant grill that allows it to be used in high humidity environments.
Specifications
- Dimensions: 10 x 6.8 x 4.8 inches
- Cut-out dimensions: 8.0 x 1.8 inches
- Built-in depth: 3.4 inches
- Weight: 2.4 pounds
- Heat resistance: 30.0 °C
- Humidity resistance: 2.0 – 2.6 g/m³
- Ingress Protection: IP44
Installation Procedure
-
Cut a hole in the wall / ceiling on the desired mounting location of the loudspeaker with a diameter of 120 mm.
-
Take the loudspeaker, and remove the front grill. The front grill is attached to the loudspeakers basket by a simple clicking system, and can be easily removed by carefully clicking the front grill away from the loudspeaker’s housing.
-
Provide the loudspeaker connection cable through the mounting hole.
-
Connect the loudspeaker to the output terminals of the amplifier.
Note: Notice the polarity markings when connecting the loudspeaker. -
Place the loudspeaker on the desired mounting location, and put the loudspeaker’s housing through the cut hole. Fasten the loudspeaker by putting four screws through the provided holes, and tighten them. Always use the proper fasteners, depending of the mounting surface.
Note: On the bottom side where the connection terminals of the loudspeaker are located, there’s a gap provided in the loudspeaker housing and front grill. This gap is meant to let the moisture flow out of the loudspeaker. Always make sure this gap is mounted on the bottom side of the loudspeaker, when mounted in vertical position. -
Once the mounting screws are tightened, the front grill can be assembled to the loudspeaker. This can be done by simply clicking the front grill to the loudspeaker’s housing. Notice the front grill will only fit in one position, because of the gap to let the moisture flow out on the bottom side.
TECHNICAL DATA
- Maximal Power: 40 Watt
- RMS Power: 20 Watt
- Impedance: Ohm8
- Sensitivity (1W / 1m): 86 dB
- Max SPL: 99 dB
- Frequency response ( ± 3 dB) Drivers: 75 Hz – 20 kHz H1” F Co axial 5” LF
DIMENSION
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>